1.
Drawing process and design of die for car C-shaped pillar reinforcement plate
轿车C柱加强板拉深工艺与拉深模设计
2.
Experimental Investigation and Numerical Simulation of Micro Deep Drawing;
微拉深工艺的实验研究及计算机模拟
3.
The Theoretical and Experimental Research on Drawing Technology of Curved Die;
曲面凹模拉深工艺的理论与试验研究
4.
Research on Micro-Forming Process of C2680 Yellow Brass Foil;
C2680黄铜箔微圆筒拉深工艺研究
5.
A Brief Discussion on the Calculating Method of the Drawing Technique of the Wide Flange Tubby Work;
宽凸缘筒形件拉深工艺计算方法初探
6.
Study on the Deep Drawing of AZ31 Magnesium Alloy Sheet
AZ31镁合金板材拉深工艺的研究
7.
Drawing of Cold Stamping Process of Bearing Frame and Die Design
轴承架的冷冲压拉深工艺及模具设计
8.
Approximation Calculation of Drawing Technology of Flange Cylindrical Parts
有凸缘圆筒形件的拉深工艺计算分析
9.
Experimental study of hot deep drawing for twin-roll-cast AZ31 alloy
AZ31镁合金铸轧板材热拉深工艺研究
10.
The Theoretical Research on Drawing Process of Camber Die and Its Software;
曲面凹模拉深工艺的理论研究及其软件设计
11.
Research on the Cylindrical Cup by Hydrodynamic Deep Drawing Based on Numerical Simulation
基于数值模拟的锥形件充液拉深工艺研究
12.
Research on the Automobile Panels Forming by Hydrodynamic Deep Drawing Based on Numerical Simulation
基于数值模拟的汽车覆盖件充液拉深工艺研究
13.
FEM Simulation on New Deep Drawing Process to Blank with Technique Holes
带工艺孔的板坯拉深新工艺有限元模拟
14.
The Application of DYNAFORM in the Optimization of the Drawing Process;
DYNAFORM在拉深件工艺优化上的应用
15.
Analysis and optimization of drawing process for interior car door panel
汽车门内板拉深成形工艺分析与优化
16.
A New Process of Hydro-mechanical Deep Drawing for Magnesium Alloy Sheets at Gradient Temperature
镁合金板材液压梯温拉深成形新工艺
17.
Research Complex Strengthening Technology of Automotive Fan Belt Plate Composite Drawing Die
汽车风扇带盘拉深模具复合强化工艺研究
18.
The Hot Stamping Forming Simulation of the Auto Rightpanel and Optimization Design of Process Parameters
汽车右托架热拉深数值模拟及工艺参数优化