1) explosive bonding
爆炸接合
1.
Some problems dealt with the clad plates by explosive bonding were discussed.
讨论了爆炸接合复合板材研究中存在的问题,认为复合板材接合界面涉及到金属融体的非平衡凝固过程,可能会存在马氏体等固态相变,但不可能形成非晶态。
2) explosive welding
爆炸接合
1.
The microstructure of the interface and properties of 00Cr18Ni5Mo3Si2/16Mn clad steel plate produced by explosive welding were investigated by means of HRTEM,TEM and SEM.
用HRTEM、TEM和SEM研究了 0 0Cr18Ni5Mo3Si2 16Mn爆炸接合复合板性能及接合界面微区组织结构。
3) explosion cladding joint
爆炸复合接头
1.
On shear strength testing method of explosion cladding joint;
爆炸复合接头剪切强度测试方法研究
5) explosive welding
爆炸焊接
1.
Investigation on microstructure at the bonding interface of TiC cermet/steel composite plate prepared by explosive welding;
TiC硬质合金/碳钢爆炸焊接复合板界面微观组织
2.
Numerical analysis of explosive welding interface layer based on δ function;
基于δ函数的爆炸焊接界面应力场数值分析
6) explosion welding
爆炸焊接
1.
This paper presents an experimental study on the inward explosion welding of the clad tube onto the base tube.
本文对基管与复管的外包爆炸焊接进行了实验研究,观察了爆炸焊接界面的组织和波形,分析了用水作为铜管爆炸焊接的柔性芯模在减小基管爆炸缩径上的作用。
2.
By adjusting explosion speed and density, interior explosion welding of the Al /stainless steel thin walled clad tube was researched (L/D≈60).
通过调整爆炸物的爆速、松装密度等参数,采用内爆炸法对铝/不锈钢细长双金属复合管(L/D≈60)的爆炸焊接进行初步的研究。
3.
Under normal conditions,after explosion welding,no welding can be found in the area of the detonator,but serious damages and deformations can be found in its surrounding areas,which affects adversely the quality of the material.
在爆炸焊接工艺中,存在一种称为边界效应的物理现象。
补充资料：核爆炸地震波探测(见核爆炸探测)
核爆炸地震波探测(见核爆炸探测)
nuclear explosion seismic detection
hebaozho dizhenbo tanee核爆炸地震波探测(nuclear explos，onseismie detecuon)见核爆炸探汉，l。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条