1) Side Parting
侧向分型
1.
And the design of the feed system,cavity and core,side parting and core-pulling mechanism were stated in detail.
分析了气压瓶盖的结构及工艺特点,介绍了瓶盖注射模具的结构和工作过程,并详细介绍了模具浇注系统,凸凹模及侧向分型与抽芯机构的设计。
2.
Through the design of the injection mould for yarn-doubling pipes,the methods for deˉsigning the side parting structure and the reverse guide mechanism are introduced.
通过并线管体注射模设计 ,阐述了该模具侧向分型及倒滑机构的设计方法 ,探讨了斜滑块侧向运动的设计要点 ,保证了脱模的可靠
3.
Since the mould requires core pulling on four directions,various side parting mechanisms have been used and are mainly introˉduced.
由于该模具需要4个方向抽芯 ,因此选择了多种侧向分型机构并作了重点介绍 ,同时对拉料杆设在定模的浇注系统、顶出机构和模具的工作过程等作了简要说
2) undercut moulding
侧向分型模
3) split
[英][splɪt] [美][splɪt]
侧向分型,分型
4) side parting and core-pulling
侧向分型和抽芯
1.
An injection mould with side parting and core-pulling mechanism was developed based on UG software for moulding the top cover of a type of fan governor.
以风扇调速器上盖为例,针对制品存在两面散热槽的结构特点,阐述了利用UG软件设计带侧向分型与抽芯机构注射模的方法,介绍了在UG NX环境下进行注射模设计的流程,着重阐述当制品存在侧向孔、槽时,分型面、侧向分型和抽芯机构的设计方法和技巧。
5) side core_pulling
侧向型芯
1.
Through the design of the injection mould for the mesh textile tubes,the design methods for the side core_pulling mechanism and the guide mechanism were stated.
通过对网眼络纱管注射模的设计 ,阐述了该模具侧向型芯及导滑机构的设计方法 ,解决了该塑件多向抽芯的困难 ,并通过设计锁紧装置 ,保证了锁模的可靠性 ,从而保证了产品的质
6) side core
侧向芯型
补充资料：阻尼型电容分压器(见分压器)
阻尼型电容分压器(见分压器)
damped capacitor voltage dividers
阻尼型电粤万压藉一”divider尽)见分压器(dam卯d eapaei、orvoltage
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条