1) cross component
侧向分量
2) side edge vector of pyramid
侧棱向量
3) Side Parting
侧向分型
1.
And the design of the feed system,cavity and core,side parting and core-pulling mechanism were stated in detail.
分析了气压瓶盖的结构及工艺特点,介绍了瓶盖注射模具的结构和工作过程,并详细介绍了模具浇注系统,凸凹模及侧向分型与抽芯机构的设计。
2.
Through the design of the injection mould for yarn-doubling pipes,the methods for deˉsigning the side parting structure and the reverse guide mechanism are introduced.
通过并线管体注射模设计 ,阐述了该模具侧向分型及倒滑机构的设计方法 ,探讨了斜滑块侧向运动的设计要点 ,保证了脱模的可靠
3.
Since the mould requires core pulling on four directions,various side parting mechanisms have been used and are mainly introˉduced.
由于该模具需要4个方向抽芯 ,因此选择了多种侧向分型机构并作了重点介绍 ,同时对拉料杆设在定模的浇注系统、顶出机构和模具的工作过程等作了简要说
4) side-branching
侧向分支
1.
The calculated results indicate that conserved noise introduced in the temperature equation drives the morphological instability on the sides of dendrites and is dominant origin of side-branching,while the side branching is unaffected with inclusion of the non-conserved noise in phase-field equation,so it can be negligible from the point of view of computational .
使用耦合热扰动的相场模型,对枝晶生长过程中噪声引发侧向分支的形成进行了研究。
6) lateral component
侧向分力
补充资料：侧棱
侧棱
侧棱 病名。即横产。清·员从云《产科一得》：“手先出者，名曰侧棱。”
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条