1) rupture surface
层间断面
1.
The analysis of rupture surface of the board indicated that the rupture of the board manufactured with the content fibers was mainly caused by fibers separation each other;on .
结果表明,未经漆酶处理的纤维表面光滑;经漆酶处理后纤维表面出现孔洞,纤维分丝;漆酶处理纤维压制的纤维板表面,活化木素碎片重新固化,在纤维表面形成一层较厚的包覆层,纤维之间产生自黏合作用而结合紧密;未经漆酶处理的纤维板层间断面,主要由纤维分离形成;而漆酶处理纤维板断面,部分由纤维断裂形成,在氧气存在条件下的漆酶处理试样,此效果更为显著。
2) Interlayer
层间
1.
How to improve interlayer adhesive force of bituminous concrete pavement;
论如何提高沥青混凝土路面层间粘结力
2.
This paper describes characteristics of montmorillonite interlayer water and factors affecting the swelling with hydration and the contraction with dehydration.
本文回顾了蒙脱石层间水性质、层间水化膨胀和脱水收缩的影响因素,提出蒙脱石层间的固溶体特征,在总结蒙脱石脱水作用与地面沉降关系研究成果的基础上,提出了用蒙脱石脱水作用研究地面沉降的思路。
3) between laminates
层间
1.
The results show that the strengthening effectes in and between laminates increase along with prolonging of aging time at 150℃, leading to the increase of strength and the decrease of the plasticity of the alloy.
１５０℃时效过程中，延长时效时间可加强层内与层间两种强化机制的作用，从而使合金强度升高，塑性下降。
4) interlayer interference
层间干扰
1.
In order to solve the problems of serious interlayer interference and low productivity of low pressure layer in heterogeneous reservoir multilayer commingled well, the research of separate-layer oil production technology with constant displacement is carried out.
针对非均质油藏多层合采油井开采层间干扰严重、低压层产油潜力动用低的问题,开展了恒排量分层采油工艺技术研究。
2.
The degree of interlayer interference,technical countermeasures of eliminating the interference and corresponding technical.
在建立层间无窜流双层模型的基础上,利用数值模拟方法和单因素、正交因素分析方法,获得薄层油藏合采开发层间干扰程度、消除或降低干扰程度的技术对策以及相应的技术图版。
3.
Also, the productivity, interlayer interference and corresponding p.
气井系统试井指示曲线常呈现异常,为了利用这些异常资料评价多层气藏的生产能力及流入动态、合理地划分开发层系,建立了二项式-单点法联解的方法,以处理这些异常试井资料,并得到气井各层的唯一的试井指示曲线和唯一的流入动态曲线;在此基础上,进一步分析多层气藏气井的生产能力、层间干扰,以及适宜的分采与合采方式。
5) interlayer rock body
层间岩体
1.
In order to ensure the safety of long-wall mining over an old rib pillar mining area,the stability of interlayer rock body under the action of mining-induced pressure needs to be evaluated and rational technical parameters for the long-wall mining determined.
为保证刀柱式老采空区上行长壁开采安全,需要对层间岩体在采动压力作用下的稳定性进行评价,并合理确定长壁工作面的开采技术参数。
6) the level strips
层间剥离
参考词条
补充资料：异形断面钢材(见异形断面型材)
异形断面钢材(见异形断面型材)
special section steel
，一、u以uu、’“飞豆on gQngC01异形断面钢材(speeial Seetion steel)见异形断面型材。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。