1) Alumina sol
铝溶胶
1.
In-situ colloidal forming of ceramics is the most promising method in making the near-net-shape and complicated ceramics, to which silica and alumina sol have been widely applied.
陶瓷原位胶态成形方法是制备近净尺寸复杂陶瓷部件最具应用前景的方法,硅溶胶、铝溶胶也越来越多的应用于其中。
2.
For solving the problem on the degradation of light efficient of BAM phosphor,BAM phosphor was coated with alumina sol(the diameter of the particle is about 10nm) making an alumina protective film around the individual powder particle of BAM.
为改进稀土三基色荧光粉尤其是BAM荧光粉的光衰问题,采用铝溶胶对BAM荧光粉粉体进行表面处理,获得了包覆氧化铝膜层的BAM粉。
2) aluminum sol
铝溶胶
1.
A method on rapid preparation of aluminum sol
一种铝溶胶的快速制备方法
2.
The paper used inorganic salt Al(NO3)3·9H2O as the raw materials and sol-gel method to prepare aluminum sol,XRD and TG-DTA were used to characterize the properties of xerogel.
以廉价的无机盐为原料,采用溶胶-凝胶法制备了性能良好的铝溶胶,采用X射线衍射分析(XRD)和差热热重分析(TG-DTA)现代测试技术对干燥后的凝胶进行物相分析和热稳定性分析。
3.
The effects of process conditions such as HC1 concentration, reaction temperature, the height of AI bed, and amount of system circle on the quality indexes of aluminum sol were investigated by experiment.
试验考察了铝溶胶生产工艺条件对产品质量指标的影响。
3) alumina sol
氧化铝溶胶
1.
Al2O3 ceramic coatings were prepared on mild steel substrates with alumina sol as precursor by electrophoretic deposition and low-temperature sintering.
以氧化铝溶胶为前驱体,采用电泳沉积和低温煅烧法在低碳钢基体上制备了氧化铝陶瓷涂层,并对其成分、表面形貌及耐蚀性进行了研究。
2.
In order to reduce the ratio of the anode oxidation and excessive anode consumption,the writer puts forward a method that the relatively compact alumina coatings(film),alumina sol as the basic cohere component, is prepared on carbon anode surface by original located solidification.
提出采用在炭素阳极表面原位固化制备以氧化铝溶胶为基本粘结相、相对致密的氧化铝涂层(膜)的方法,达到减少阳极氧化、降低阳极过量消耗的目的。
3.
Based on the infrared anomalous dispersion of compact alumina film, the character of alumina sols and the processing for fabricating compact alumina film were studied by using sol-gel method.
本文基于致密氧化铝膜的红外反常色散特性，结合溶胶-凝胶技术，采用浸渍提拉法、旋覆法和电泳沉积工艺，对氧化铝溶胶的性质和致密氧化铝膜的制备工艺进行了研究。
4) aluminosilica sol
铝硅酸溶胶
1.
The aggregation behavior of aluminosilica sol under different pH was studied.
本文研究了铝硅酸溶胶在不同ｐＨ值条件下的聚集特性，发现铝硅酸溶胶加无机酸后的聚集过程是一种聚沉或絮凝过程，无法通过用无机酸调节ｐＨ值的方法使得铝硅酸溶胶胶凝成具有足够强度的凝胶，溶胶在ｐＨ＝７０左右时就开始发生聚沉，在ｐＨ＝３５左右时聚沉速度最快，当ｐＨ≤３０时，不仅已聚集的胶粒又重新分散，而且原始胶粒也分散成小胶粒，溶胶稳定，文中对铝硅酸溶胶在不同ｐＨ值条件下的聚集机理进行了探
5) aluminium hydroxide sol
氢氧化铝溶胶
1.
Study on preparing stable aluminium hydroxide sol through aluminium by nitric acid;
纯铝制备稳定氢氧化铝溶胶的研究
6) Nano-scaled Al_2O_3 sol
纳米氧化铝溶胶
补充资料：135kA中间下料预焙阳极铝电解槽(抚顺铝厂)
135kA中间下料预焙阳极铝电解槽(抚顺铝厂)
赢 135kA中间下料预焙阳极铝电解槽(抚顺铝厂)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条