In order to study the composition segregation regions in bulk metallic glass,small angle X-ray scattering(SAXS) technique and differential scanning calorimetry(DSC) were used to investigate the evolution of microstructure in Cu55Zr30Ti15 amorphous alloy heated from 310 K to 783 K.

Current study and advances on superplastic forming of bulk amorphous alloy;

Influence of Oxidation on the Accuracy of DSC and TG Measurements for Amorphous Alloys;

Study of behavior of non-isothermal crystallization of amorphous alloy Mg_(65)Cu_(22)Ni_3Y_(10);

Correlation between crystallization kinetics of amorphous alloys and primary phases during crystallization;

Crystallization kinetics of Ni_(59)Zr_(16)Ti_(13)Si_3Sn_2Nb_7 amorphous alloys;

5 amorphous alloys were prepared by a single roller melt-spinning technique in an air atmosphere.

Plastic deformation of bulk metallic glass (BMG) Zr55Al10Ni5Cu30 was investigated by nanoindentation experiments at room temperature.

The deformation and fracture behavior under quasi-static compressive loading of a bulk metallic glass,Zr-Ti-Ni-Cu,was studied using instron universal-testing machine(IUTM) and scanning electron microscopy(SEM) at room temperature.

5 metallic glass has been studied by DSC and XRD.

Cu40Ti60-xZrx(x=0,10,30,50) amorphous alloys were fabricated successfully by using mechanical alloying method.

The GMI effects have been observed in two Co-Rich amorphous ribbons and a Fe-Rich alloy ribbon.

The application of the homemade 1K101 amorphous core in induction module is reported in this paper.

Preparation and application in welding of bulk Mg_(65)Cu_(22)Ni_3Y_(10) amorphous alloys;

Formation and crystallized behavior of Mg_(65)Cu_(25)Y_(10) amorphous alloy;

Study for hydrogenation of furfuryl alcohol to tetrafurfural alcohol on NiB/SiO_2 amorphous alloy catalyst;