1) Shell thickness
坯壳厚度
1.
The solidified shell thickness of Jigang slab caster is measured by nail-shooting technology,and the measuring results are compared with theoretical calculation values.
采用射钉法测量济钢大板坯连铸机坯壳厚度,将实测结果与理论计算的结果进行对比,修正了综合凝固系数,指导改造了二冷喷嘴的结构,加强了铸坯冷却强度,年铸坯产量达225万t。
2.
The application of nail-shooting technique in the shell thickness measuring was introduced.
介绍了射钉法在测量连铸坯凝固坯壳厚度方面的应用情况。
3.
Unsteady temperature distribution and shell thickness in the continuous casting bloom were numerically simulated.
利用数值模拟手段计算连铸方坯中非稳态温度场分布及坯壳厚度,根据所需的凝固分率所对应的坯壳厚度点来预报轻压下设备的轻压下位置。
2) solidified shell thickness
坯壳厚度
1.
Determination of solidified shell thickness of continuous casting slab at Angang;
鞍钢厚板坯凝固坯壳厚度的测定
2.
The surface temperature and the solidified shell thickness of round billet are strongly influ.
由于拉速变化引起计算空间内质量流量的变化,圆坯的表面温度和坯壳厚度受拉速强烈影响。
3.
The solidified shell thickness and solidification coefficient of slab in the secondary cooling zone on Pangang curved slab caster have been studied,by use of “pin shoot”method.
研究工作运用“射钉法”,准确地标定了攀钢弧形板坯连铸机二冷区凝固坯壳厚度及凝固系数 ,为评价现有二冷系统的冷却能力、制定合理的二冷配水制度和高拉速条件下的工艺参数提供了重要依据。
3) minimum mould exit shell thickness
安全坯壳厚度
1.
The value of the minimum mould exit shell thickness(MEST)is one of key factors to consider for continuous casting machine design and the strand cooling schemes.
结晶器出口的安全坯壳厚度确定一直是连铸设备与工艺设计中十分关注的问题。
5) Parison thicliness
型坯厚度
6) paper thinkness
纸坯厚度
1.
Application of laser displacement sensor in the paper thinkness on-line measurement;
激光位移传感器在纸坯厚度在线检测中的应用
补充资料：实坯坯
1.见"实丕丕"。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条