1) blend flat sheet membrane
共混平板膜
2) blended membrane
共混膜
1.
The blended membrane is prepared with Konjac glucomanna (KGM) and Carrageenan as materials.
结果表明,魔芋葡甘聚糖与卡拉胶用量比为6:4时,共混膜的能达到较好的效果。
2.
A series of blended membranes with various fullerene ethanolamine derivative contents were prepared using the natural polymer chitosan as membrane material by casting method.
通过溶液共混及流涎成膜法制备了一系列不同C60乙醇胺含量的壳聚糖共混膜,以及含Cu(Ⅱ)的C60乙醇胺/壳聚糖共混膜。
3.
The membranes were prepared by blending polyaniline with poly(vinylidene fluoride), and the gas-separation characteristics of pure PVDF membrane and blended membranes were investigated.
采用ＰＡＮＩ与ＰＶＤＦ共混制膜,并对共混膜和ＰＶＤＦ膜的气体分离性能进行对比研究。
3) blending membrane
共混膜
1.
Study of PES-PAN blending membrane;
聚醚砜-聚丙烯腈共混膜的研究
2.
Preparation of PES/CA blending membrane and its application in membrane bioreactor
聚醚砜/醋酸纤维素共混膜的制备及其在膜生物反应器中的应用研究
3.
The blending membranes of perfluorinated sulfonic resin with polyvinylidene fluoride(PVDF) were prepared by the method of solution casting.
为了降低质子交换膜的成本,选用聚偏氟乙烯和全氟磺酸树脂为原料,采用溶液-浇铸法制备了全氟磺酸树脂/聚偏氟乙烯的共混膜。
4) blend films
共混膜
1.
PP-g-MAH/down powder blend films with different content of powder were obtained after down powder were pretreated by different kinds of plasticizers,and the influence of down powder content,the type of PP,and the kind of plasticizers on the mechanical properties of blend films were studied.
采用不同增塑剂对羽绒粉体处理,制备了不同羽绒含量的马来酸酐接枝聚丙烯(PP-g-MAH)/羽绒粉体共混膜,分析了粉体含量、PP种类及不同增塑剂对共混膜力学性能的影响。
2.
The cassava starch-chitosan blend films were prepared by solution method.
以溶液共混法制备了木薯淀粉/壳聚糖共混膜,测试了其力学性能、水蒸气透过率、阻氧性及抗菌性能,同时通过红外光谱、X-射线、扫描电镜表征了其结构。
3.
PANI and Polystyrene were cosolved in xylene and casted into blend films.
将聚苯胺、聚苯乙烯共溶于二甲苯后制成共混膜,用广角X射线衍射、红外光谱、偏光显微镜分析了共混膜的相形态。
5) blend film
共混膜
1.
Properties of blend films prepared by water-insoluble silk fibroin powder and medical polyurethane;
非水溶性丝素粉体与聚氨酯共混膜的性能
2.
The blend films was successfully prepared by coagulating a mixture of sodium alginate and carboxylmethyl konjac glucomannan in aqueous solution with 5% CaCl_2,and then by treating with 1% HCl aqueous solution.
再利用溶液共混法制备海藻酸钠-羧甲基葡甘聚糖共混膜,通过红外光谱、X-射线衍射、原子吸收光谱和扫描电镜对共混膜的结构进行了表征;并测定了不同配比共混膜的拉伸强度、断裂伸长率,吸水率和水蒸汽透过率,同时考察了NaCl浓度对共混膜吸水率的影响。
3.
Collagen-chitosan-polyvinyl pyrrolidone(PVP)blend films were prepared successfully by solution method,and characterized by FT-IR,X-ray diffraction and optical transmittance.
利用溶液共混法成功制备了新型生物膜材料——胶原蛋白—壳聚糖—聚乙烯吡咯烷酮共混膜,通过红外光谱、X-射线衍射和透光率测试表征了共混膜的结构,同时测定了共混膜的力学性能,考察了溶液pH值对共混膜吸水率的影响。
6) blend support membrane
共混基膜
1.
The PVDF/PEU blend support membranes were prepared by phase-inversion method, and the grafted membranes with pH-sensitive effect were prepared by UV photografting polyacrylic acid onto the blend support membranes with benzophenone(BP) as initiator.
采用相转化法制备PVDF/PEU共混基膜。
补充资料：平板式膜组件
分子式：
CAS号：
性质：也称平板式膜组件。由平板式膜和支撑板组成的膜分离单元设备。支撑板的两侧表面有窄缝，其内腔有供透过液流通的通道，支撑板的表面与膜相贴，对膜起支撑作用，有的组件还设有导流板，对料液起导流作用。板框组件分为系紧螺栓式、耐压容器式等几种。由许多相同的板框组件组装在一起构成板框式膜器。
CAS号：
性质：也称平板式膜组件。由平板式膜和支撑板组成的膜分离单元设备。支撑板的两侧表面有窄缝，其内腔有供透过液流通的通道，支撑板的表面与膜相贴，对膜起支撑作用，有的组件还设有导流板，对料液起导流作用。板框组件分为系紧螺栓式、耐压容器式等几种。由许多相同的板框组件组装在一起构成板框式膜器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条