Introduction and analysis on drafit of International standard of aluminum ingot;

Realization of Fuzzy Control System Based on PLC for Aluminum Ingot Casting Machine;

And also a method for the determination of micro amount of Al_2O_3 in aluminum ingot samples by spectrophotometry with aluminon as chromatogenic agent has been developed.

Determination of Si,Fe,Ga,Cu and Mg in Exported Aluminium Ingot by SOLIS-500 Solids Sampling System;

Simultaneous Determination of 8 Impurity Elements in Aluminium Ingot by ICP-AES;

Development of new automatic stacker of aluminium ingots LDJ-20;

Analysis of influencing factors on aluminum ingots surface quality and its improvement measures

The bar-code technologic scheme is proposed in this paper about the management of Aluminum ingots for remelting in the production of Aluminum smelter, including product check-up, identifier, measurement, putting Aluminim ingots in the storage, arrangement of the materials in stock, taking out/loading and other problem in the technologic process.

The production process and control system of 20kg aluminum ingots continues casting machine are described,and the production technology figure,control system diagram are derived in this paper.

Investigation of Microstructure and Mechanical Properties for A356 Alloys Melted with Grain-refining Aluminium Ingots;

The results show that the grains of the test samples added Ti by grain-refining aluminium ingots(GRAI) are fine,and precipitated phases are fine and disperse in as-cast state,and its mechanical properties is the best,especially its elongation is markedly higher than that of other test samples.

Through the experiment on grain refining efficiency,grain average diamaters of grain-refining aluminium ingots are less than 350 μm.

The structure and usage of clamping device of scalper for aluminum stock are introduced in the paper.