1) Al_2O_3 Ceramic
Al_2O_3陶瓷
1.
Experimental Study of Laser Milling on Al_2O_3 Ceramic;
Al_2O_3陶瓷的激光铣削试验研究
2.
Based on the composite depositing technology by the arc-added glow discharge, the composite target was used to deposit Cu and Ti alloy on the Al_2O_3 ceramics surface, realizing the surface alloying of A1_2O_3 ceramics.
基于加弧辉光复合渗镀技术,采用自行研制的复合靶对Al_2O_3陶瓷表面进行Cu、Ti复合渗镀,实现了Al_O_3陶瓷表面合金化。
3.
In brazing of Al_2O_3 ceramic and nickel, filler metal couldn’t fully metal below 1000℃.
研究发现活性钎焊法钎焊Al_2O_3陶瓷和金属Ni,1000℃以下由于钎料熔化不充分,接头质量较差。
2) Alumina ceramics
Al_2O_3陶瓷
1.
Low temperature sintering of alumina ceramics is one of the very important research work in ceramic area,introducing additives to ceramics is very useful method.
本文以MgO-MnO_2-TiO_2-SiO_2复相添加剂作为氧化铝陶瓷的烧结助剂,采用注浆成型工艺,在1400℃、1450℃下空气中烧结,保温1h制备低温烧结氧化铝陶瓷;研究了添加剂SiO_2的含量与粒度,烧结温度对低温烧结Al_2O_3陶瓷材料性能的影响。
4) alumina ceramic
Al_2O_3陶瓷
1.
The conventional alumina ceramic is difficult to obtain full density due to its low sinterability, so the material is very brittle and is limited in the application.
Al_2O_3陶瓷是一种重要的抗氧化、抗腐蚀的高温结构陶瓷材料。
2.
In order to meet the urgent requirement of enhancing wear-resistant of mechanical equipment in metallurgy, chemical and power industry, active brazing of alumina ceramics to 16Mn steel was carried out using investigated Ag-Cu eutectic+TiH_2 active powder brazes.
本文针对冶金、化工、电力等行业中,对于提高机械设备耐磨性的迫切要求,通过在Ag-Cu共晶钎料中添加TiH_2活性粉末,进行Al_2O_3陶瓷与16Mn钢的钎焊连接。
6) Al 2O 3 WO 3
Al_2O_3-WO_3陶瓷
补充资料：电解质陶瓷(见快离子导体陶瓷)
电解质陶瓷(见快离子导体陶瓷)
electrolyte ceramics
电解质陶瓷electrolyte陶瓷。Cera』n1CS即快离子导体
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条