说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 冷喷涂
1)  cold spray
冷喷涂
1.
Research on computational simulation of two-phase jet flow in cold spray technology for manufacture of functional coatings;
冷喷涂制备功能涂层工艺中两相射流数值模拟研究
2.
Rapidly Solidified Zn-Al Powder on Surface of Mg Alloy by Cold Spray Method;
镁合金表面冷喷涂快凝Zn-Al合金粉末的研究
3.
Wear behavior of cold spray Zn-Al alloy coating on magnesium alloy;
镁合金表面锌铝合金冷喷涂层的磨损行为
2)  cold spraying
冷喷涂
1.
Study of incidence angle of particle on its coating formation in cold spraying;
粒子入射角度对冷喷涂涂层形成的影响
2.
Influence of heat treatment on interfacial diffusion of Al alloy cold spraying coating on magnesium alloy;
镁合金表面冷喷涂铝合金的界面扩散行为
3.
Applications and prospect of cold spraying technique in welding engineering;
冷喷涂在焊接工程中的应用与展望
3)  cold gas dynamic spray
冷喷涂
1.
Advantages and disadvantages of five kinds of thermal spraying technologies including high velocity oxygen fuel flame spraying process, hypersonic plasma spray process, laser spray process, reactive spray process and cold gas dynamic spray process were analyzed.
对超音速火焰喷涂、超音速等离子喷涂、激光喷涂、反应热喷涂和冷喷涂等5种不同的热喷涂工艺的优缺点进行了分析。
2.
Numerical simulations are performed for the gas particle two phase flow in the cold gas dynamic spray process to investigate the acceleration of micro and nano particles with diameters ranging from 100 nm to 50 μm.
冷喷涂过程中,由于基板的存在,板前有激波出现,从而对喷涂粒子的运动产生影响。
3.
The particle velocity in cold gas dynamic spray (CGDS) is one of the most important factor that can determine the property of the bonding to the substrate.
冷喷涂(CGDS)过程中粒子速度是决定粒子粘附性的最重要的因素之一。
4)  cold gas dynamic spraying
冷喷涂
1.
Properties of Cu coating in supersonic cold gas dynamic spraying;
超音速冷喷涂铜涂层特性分析
2.
Cold gas dynamic spraying(CGDS) was a newly-developed coating techniques proposed in 1980 's, in which the carrier gas was accelerated to very high speed (usually supersonic) by de Laval nozzle, then the particles carried by gas impinged on the substrate and form coating.
冷气体动力喷涂(简称冷喷涂)是上个世纪80年代提出的一种全新的喷涂工艺,它是利用拉法尔喷管将输送气体加速到超音速,使之携带喷涂粒子撞击基板形成涂层。
3.
Copper coating on aluminum substrate was prepared by cold gas dynamic spraying for hydrogen production through methanol steam reforming.
9%,表明能用冷喷涂技术制备甲醇水蒸气重整制氢的催化涂层。
5)  cold-end coating
冷端喷涂
6)  Cold Spray Technology
冷喷涂技术
补充资料:长春冷弯型钢总厂生产的异形冷弯型钢


长春冷弯型钢总厂生产的异形冷弯型钢


  长春冷弯型钢总厂生产的异形冷弯型钢
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条