1) area resistance
面电阻
1.
The affecting factors of measuring the area resistance of ion-exchange membrane with conductivity method;
影响电导率法测定离子交换膜的面电阻的因素
2.
In the paper, two key properties(permeability of vanadium ion and area resistance)of five different ion exchange membranes, that is Nafion, Japan-160, Japan-80, FYM produced in Japan and homogeneous membrane, and the effective factors were studied.
考察了Nafion、日-160、日-80、FYM(日本产Nafion膜)和均相膜5种离子交换膜的两个关键性能(渗透性和面电阻)及其影响因素,对均相膜的化学稳定性进行了初步研究,并对两种膜进行了改性。
3.
The preparation, the area resistance and the stability of the membranes were introduced and investigated,comparing with other commercial proton conductive membranes.
本文分析介绍了本实验室制备质了传导膜的工艺,以及面电阻、化学稳定性等膜性能指标,并与现有商业化质子传导膜进行比较。
2) sheet resistance
面电阻
1.
Surface morphology, optical transmittance and sheet resistance were examined and characterized.
X射线衍射仪、扫描电镜、紫外可见分光光度计与四探针仪分别用于表征样品的晶体结构、表面形貌、透光率与面电阻。
2.
The optical transmittance and the sheet resistance of Cu films with different thickness were measured.
在室温条件下,用直流磁控溅射Cu靶制备出了不同厚度的Cu膜,测量了Cu膜的光学透过率和面电阻,分析了光电性质薄膜厚度的变化情况。
3) Surface Resistance
表面电阻
1.
Strain effect on microwave surface resistance of YBa_2Cu_3O_(7-δ)/LaAlO_3 and Tl_2Ba_2CaCu_2O_8/LaAlO_3 high temperature superconducting thin films;
YBa_2Cu_3O_(7-δ)/LaAlO_3和Tl_2Ba_2CaCu_2O_8/LaAlO_3高温超导薄膜内的应变对其微波表面电阻影响的研究
2.
The surface resistance Rs was measured by the four-probe method described in ASTM F 390.
分别用四探针法(ASTM F390)和双轴传输线法(ASTM D 4935-99)测量导电涤纶织物的表面电阻和电磁屏蔽效能。
3.
The results showed that the material with 5% content of carbon black could meet the requirement of the performance of motor blower fan material as the surface resistance reaching 1×108Ω.
结果表明,炭黑的质量分数为5%时,材料表面电阻率为108Ω数量级,力学性能优良,达到电机用塑料风叶材料的指标要求,并可应用于其它对抗静电性能要求较高的场合,用于制造某些结构件。
4) Surface resistivity
表面电阻
1.
Antistatic properties of carbon black (CB) filled plasticized poly(vinyl chloride) (PVC) were studied using surface resistivity tester and SEM.
采用表面电阻测试和扫描电镜 ,分析研究了软质聚氯乙烯 (PVC)树脂与炭黑 (CB)复合体系的抗静电性与炭黑含量、分布形态、PVC树脂型号及混炼塑化工艺之间的关系。
2.
When nonionic electrostatic resistant is mixed with assistant electrostatic resistant,the composite's surface resistivity will be reduced to 3×10 8Ω or below.
实验结果表明 ,八溴联苯醚与 Sb2 O3 互配体系的氧指数可达 2 7以上 ;非离子型抗静电剂配以辅助抗静电剂 ,可使材料的表面电阻降至 3× 1 0 8Ω 以
3.
In fact,the surface resistivity of these composites is analyzed.
研究复合材料的热性能、微观结构、表面电阻和结晶行为,结果都表明OMMT对PA66有明显的影响。
5) membrane surface resistance
膜面电阻
1.
Parameters including elapsed time, average current, and membrane surface resistance were measured under the same operating conditions until the electrical conductivity of dilute solution decreased to 0.
9mS·cm-1所经历的时间、平均电流和膜面电阻等参数的变化,确定了离子交换膜的污染状况,分别考察了含聚合物采油污水中的固体悬浮物、聚合物和原油对离子交换膜性能的影响。
6) area specific resistance
面比电阻
1.
Based on the study of metallic interconnect Fe-Cr-Mn alloy for solid oxide fuel cell(SOFC),some problems existing in the theoretical and experimental test of area specific resistance,and XRD analysis of oxide scale on the alloy surface are researched.
以含Mn的固体氧化物燃料电池(SOFC)金属连接体Fe-Cr-Mn合金为研究对象,探讨了目前在研究过程中面比电阻理论,面比电阻实验测试和合金表面氧化物XRD谱分析中存在的几个问题。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条