1) interface resistance
面间电阻
2) bar to bar resistance
片间电阻
1.
The meter measures bar to bar resistance and bar to bar insulation easily by the method of inputting a small constant current and basic sine wave signal to the direct current motor armature windings.
该测试仪采用恒流小电流以及基准正弦波信号输入直流电机电枢绕组的方法 ,对各种直流电机电枢绕组片间电阻以及片间绝缘进行便捷测量。
3) inter bar resistance
条间电阻
4) interlamination resistance
层间电阻
1.
The interlamination resistance of the coating is about 800 Ω·mm2 per piece for insuring good insulating property by adjusting the roller pressure and the tensile force of SF section.
通过调整涂辊压力、SF段张力,涂层层间电阻可控制在800Ω。
5) intermediate resistance
中间电阻
6) interelectrode resistance
极间电阻
1.
The results show that the interelectrode resistance of P-type mono-crystalline silicon will decrease as the available area of the electricity interface growing,but the current of cutting will increase,and positive polarity machining is suitable for discharge cutting P-type mono-crystalline silicon.
结果表明,进电有效接触面积越大,P型单晶硅材料的极间电阻就越小,切割电流也就越高,同时对于P型单晶硅放电切割宜采用正极性加工。
2.
The variation features of the interelectrode resistance of p-type silicon with different conduction mode were researched.
研究了不同进电方式条件下P型硅极间电阻的变化特征,并从进电有效接触面积的角度对其进行分析。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条