1) partially melted zone
部分熔化区
1.
Microstructure and corrosion behavior in partially melted zone of X60 steel welded by ECrNiMo-3 electrode wire;
ECrNiMo-3焊接X60钢部分熔化区组织及腐蚀行为
2.
20 mm thick 2519-T87 high strength aluminum alloy was surfacing welded,and a precipitate-free zone (PFZ) was found behind the grain boundary in partially melted zone (PMZ).
采用电弧焊对20mm厚的2519-T87高强铝合金进行表面堆焊,观察了部分熔化区出现的无析出物区(PFZ)的组织特征,并对该区域的形成机理进行了研究。
2) partial melting
部分熔化
1.
In order to improve the performances of Bi-2212/Ag tapes (mainly refer to crital current density Jc), the experiment for effects of partial melting process on Jc of the tapes was conducted.
为了提高Bi-2212/Ag带的性能(主要指临界电流密度Jc),进行了部分熔化热处理工艺对带材Jc的实验。
2.
The effect of different stages of the partial melting process on the phase component and microstructure of (Bi,Pb)-2223/Ag strip was analyzed and compared to the normal two-stage heat treatment process.
通过部分熔化处理工艺和普通两段热处理工艺的对比研究,分析了部分熔化处理工艺在不同热处理阶段对(Bi,Pb)-2223/Ag带材相组成和微结构的影响。
3) Partial melt process
部分熔化法
4) zone melting process
分区熔化法
5) partial meltingprocess
部分熔化工艺
6) partial carbonization zone
部分碳化区
1.
The conditions of the carbonization zone, partial carbonization zone and uncarbonated zone are not same as the assumed conditions of the model.
混凝土中实际存在的碳化区、部分碳化区和未碳化区与理论的模型假设条件是不同的,由此造成的酚酞测试方法可能存在一定的局限性。
补充资料：V_2O_5熔化铸片炉(峨嵋铁合金厂)
V_2O_5熔化铸片炉(峨嵋铁合金厂)
V205熔化铸片炉(峨嵋铁合．~7--)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条