1) melting region
熔化部
1.
This paper discussed the causes of pressure fluctuation of melting region in later stage of float glass furnace in detail and the countermeas ures to this fluctuation was also introduced .
针对浮法玻璃熔窑运行后期熔化部压力波动形成的原因及对策,做了较为详尽的论述。
2) partial melting
部分熔化
1.
In order to improve the performances of Bi-2212/Ag tapes (mainly refer to crital current density Jc), the experiment for effects of partial melting process on Jc of the tapes was conducted.
为了提高Bi-2212/Ag带的性能(主要指临界电流密度Jc),进行了部分熔化热处理工艺对带材Jc的实验。
2.
The effect of different stages of the partial melting process on the phase component and microstructure of (Bi,Pb)-2223/Ag strip was analyzed and compared to the normal two-stage heat treatment process.
通过部分熔化处理工艺和普通两段热处理工艺的对比研究,分析了部分熔化处理工艺在不同热处理阶段对(Bi,Pb)-2223/Ag带材相组成和微结构的影响。
3) melting procedure
熔化工部
1.
Computer management system of melting procedure in casting shop;
铸造车间熔化工部微机管理系统
4) melting inside source
内部熔化
5) partially melted zone
部分熔化区
1.
Microstructure and corrosion behavior in partially melted zone of X60 steel welded by ECrNiMo-3 electrode wire;
ECrNiMo-3焊接X60钢部分熔化区组织及腐蚀行为
2.
20 mm thick 2519-T87 high strength aluminum alloy was surfacing welded,and a precipitate-free zone (PFZ) was found behind the grain boundary in partially melted zone (PMZ).
采用电弧焊对20mm厚的2519-T87高强铝合金进行表面堆焊,观察了部分熔化区出现的无析出物区(PFZ)的组织特征,并对该区域的形成机理进行了研究。
6) Partial melt process
部分熔化法
补充资料：《乾隆平定准部回部战图》
| 《乾隆平定准部回部战图》 中国清代宫廷绘画作品。作者郎世宁、王致诚、艾启蒙、安德义。系铜版组画，共16幅，每幅纵55.4厘米 、横90.8厘米。画于乾隆廿九年(1764)，第二年完成，经广州海运至法国 ，由法兰西皇家艺术院制成铜版画，每幅印制200张。作品描绘了清乾隆二十至二十六年，平定蒙古族准噶尔部的阿睦尔撒纳和维吾尔族的布那敦、霍集占叛乱的经过。场面宏大，人物众多，景物繁复，以恢宏的气势和精致细微的手法 ，从《平定伊犁受降》到《凯宴成功诸将》,真实地表现了平叛战斗过程、规模、面貌。 |
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条