1) burning loss
烧损
1.
Some solutions are put forward by analyzing reasons of burning loss for the screwdown screw and nut on steckel mill.
通过对炉卷轧机的压下螺丝与螺母烧损的设备事故现象的分析,找出事故产生的原因,并提出了相应的解决方案。
2.
In the paper,Mg regularities of distribution and effects of Mg burning loss on mechanical property of weld bead are researched during 5A06 alloy electro beam welding.
研究了5A06合金电子束焊接时熔池内Mg元素的分布规律及Mg元素烧损对焊缝力学性能的影响。
2) Burning
[英]['bɜ:nɪŋ] [美]['bɝnɪŋ]
烧损
1.
Causes Analysis on the Commutator Surface Burning of Four High Plate Mill DC Motor and its Handling Measures;
四辊轧机直流电动机整流子表面烧损原因分析及改进措施
2.
Reason analysis and preventive measures of burning of air filters;
空气滤清器烧损原因分析及防止措施
3) burnout
[英]['bɜ:naʊt] [美]['bɝn'aut]
烧损
1.
Causes and measures of boiler burner burnout in Huaneng Yingkou Power Plant;
华能营口电厂锅炉燃烧器烧损的原因分析与解决措施
2.
This paper describes the burnout process of elastic metal-plastic pads in large pump station, analyzes the causes of the fault and proposes the methods to solve the problem.
本文介绍了大型泵站弹性金属塑料瓦一次烧损故障,分析了事故原因,提出了处理方法,并对泵站用弹性金属塑料瓦的安装、使用提出了建议。
3.
Based on observation,measurement,and specialists analysis,the main causes of burnout failure for carbon brush on said generators have been found.
根据观察、测量及分析,找出了发电机碳刷烧损事故的主要原因。
4) damage
[英]['dæmɪdʒ] [美]['dæmɪdʒ]
烧损
1.
Disposal of runner band seal damage of Unit 5 in Guangzhou Pumped Storage Power Station;
广蓄电厂5号机下止漏环烧损原因分析及处理
2.
Treatment of damaged air preheater of 300 MW boiler after fuel secondary combustion;
300MW锅炉空气预热器烧损处理
3.
Not only the equipments of traction power supply and signaling system were damaged, but also the traffic system was seriously disturbed which has made a huge economic loss for our country.
哈大线电气化铁道自2001年开通运营至今,牵引供电设备故障曾多次引发烧损电务设备的事故,不仅给牵引供电设备、电务信号设备造成了损失,还严重干扰了运输秩序。
5) burn-out
[英]['bə:n'aut] [美]['bɝn'aʊt]
烧损
1.
The article analyzes the main causes of burn-out of cables in aspects of structures, inspections of articulated neutral section and locomotive running with combination of tripping of articulated neutral section and burn-out of cables, establishes the detailed prevention measures for impr.
关节式电分相是电气化铁道接触网的重要组成部分,已在运行过程中频繁发生线索烧损故障引起变电所跳闸,严重危及行车安全。
2.
The burn-out accident occurred several times in operation of dry type hollow shunt reactor.
干式空心并联电抗器在运行中曾发生多起烧损事故。
6) loss by burning
烧损
1.
The scraper conveyer electric motor loss by burning reason carries on the multianalysis to this mine pit,proposes the solution,administratively consummates the measure.
对新岭煤矿井下刮板输送机电动机烧损原因进行详细分析,提出解决办法,从管理上完善防范措施。
补充资料：烧损
烧损
fire waste
Sh0OSUn烧损(fi re waste)钢在高温状态下因氧化而造成的损耗。从锭坯到成品的整个生产过程中钢要经过多次加热，据测定，每加热一次约有0.5%一2.5%的钢被烧损。烧损不仅造成钢的直接损失，产生的氧化铁皮还降低钢的导热能力，侵蚀炉底耐火材料，恶化炉子操作条件，对轧件顺利咬入和钢材表面质量也产生不良影响。因此，减少金属烧损是钢加热过程中的重要间题。钢的烧损(氧化)过程主要是铁与炉气中的C02、02、H20发生化学反应的过程，其反应式如下: Fe+粤。，一Feo 2-‘一_ 3Fe+202一一Fe3O- ZFe:04+今。:一3FeZo3 -一‘一”’2一‘-一‘一J Fe+CO:一FeO+CO 3Fe+4COZ一Fe3O4+4CO 3FeO+COZ一FesO;+CO Fe十HZO一FeO+HZ 3Fe+4HZO一Fe3O4十4H2 3Fe+HzO一-今Fe3O;+Hz烧损与加热温度、加热时间、炉内气氛和钢的化学成分等因素有关。加热温度越高、高温下停留的时间越长、炉内氧化性气氛愈浓，则加热时的烧损愈多。因此减少烧损的主要措施是，在满足加热工艺的条件下，适当提高加热速度，缩短加热时间;控制炉内气氛，在保证燃料完全燃烧的条件下，减少过剩的空气并防止冷空气的吸入等。此外，采取保护性气体或用保护性涂料也能减少或防止钢的氧化。 (衷康)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条