1) burned value
烧损量
2) loss rate of quality after burning
燃烧质量损失率
3) burning loss
烧损
1.
Some solutions are put forward by analyzing reasons of burning loss for the screwdown screw and nut on steckel mill.
通过对炉卷轧机的压下螺丝与螺母烧损的设备事故现象的分析,找出事故产生的原因,并提出了相应的解决方案。
2.
In the paper,Mg regularities of distribution and effects of Mg burning loss on mechanical property of weld bead are researched during 5A06 alloy electro beam welding.
研究了5A06合金电子束焊接时熔池内Mg元素的分布规律及Mg元素烧损对焊缝力学性能的影响。
4) Burning
[英]['bɜ:nɪŋ] [美]['bɝnɪŋ]
烧损
1.
Causes Analysis on the Commutator Surface Burning of Four High Plate Mill DC Motor and its Handling Measures;
四辊轧机直流电动机整流子表面烧损原因分析及改进措施
2.
Reason analysis and preventive measures of burning of air filters;
空气滤清器烧损原因分析及防止措施
5) damage
[英]['dæmɪdʒ] [美]['dæmɪdʒ]
烧损
1.
Disposal of runner band seal damage of Unit 5 in Guangzhou Pumped Storage Power Station;
广蓄电厂5号机下止漏环烧损原因分析及处理
2.
Treatment of damaged air preheater of 300 MW boiler after fuel secondary combustion;
300MW锅炉空气预热器烧损处理
3.
Not only the equipments of traction power supply and signaling system were damaged, but also the traffic system was seriously disturbed which has made a huge economic loss for our country.
哈大线电气化铁道自2001年开通运营至今,牵引供电设备故障曾多次引发烧损电务设备的事故,不仅给牵引供电设备、电务信号设备造成了损失,还严重干扰了运输秩序。
6) burnout
[英]['bɜ:naʊt] [美]['bɝn'aut]
烧损
1.
Causes and measures of boiler burner burnout in Huaneng Yingkou Power Plant;
华能营口电厂锅炉燃烧器烧损的原因分析与解决措施
2.
This paper describes the burnout process of elastic metal-plastic pads in large pump station, analyzes the causes of the fault and proposes the methods to solve the problem.
本文介绍了大型泵站弹性金属塑料瓦一次烧损故障,分析了事故原因,提出了处理方法,并对泵站用弹性金属塑料瓦的安装、使用提出了建议。
3.
Based on observation,measurement,and specialists analysis,the main causes of burnout failure for carbon brush on said generators have been found.
根据观察、测量及分析,找出了发电机碳刷烧损事故的主要原因。
补充资料：枯损量
1.指森林中由于自然枯死和风倒﹑雪压﹑病虫﹑火灾等危害而减少的蓄积量。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条