1) elevated initial static temperature
高初始静温
2) initial temperature
初始温度
1.
Na_8+Na_8 collisional dynamics at different initial temperatures;
不同初始温度时Na_8+Na_8团簇碰撞动力学研究
2.
The initial temperature distribution function of the foundry moulds when heat radiated and infused by hot iron are put forward.
提出了铸型受热辐射和铁水浸泡的初始温度分布函数，并考虑了结晶潜热和强制冷却工艺等因素，使模拟精度高，误差在５％以内，为研究厚大断面球铁铸件的凝固规律提供了较可靠的参考依据。
3.
How to determine initial temperature and adiabatic temperature rise is one of the most principal factors for RCC(Roller Compacted Concrete) dam,which will influence the accuracy and quantity of simulation analysis for temperature field.
碾压混凝土浇筑层的初始温度和绝热温升是碾压混凝土坝设计中的常见问题之一,直接关系到温度场仿真计算的精度和计算量问题。
3) initial temperature difference
初始温差
1.
The initial temperature difference of the air cooling tower is the main factor which affects the safe and economical operation of air cooling unit,and it s also an important parameter of the cold-end design for air cooling unit.
空冷塔初始温差是影响空冷机组安全经济运行的重要因素,是空冷机组冷端设计的一项重要参数。
2.
Adopting the method of remaining the same inlet air temperature and fixing initial temperature difference,some pivotal parameters of the single-row tube heat exchanger are investigated synthetically,including flow pressure drop and air-side heat transfer coefficients.
采用保持空气入口温度不变,同时固定初始温差的方法,综合考察了单排管换热器的流动阻力和空气侧传热系数等关键参数,得到了在不同空气迎面风速下流动阻力和传热的关联方程式,为工程优化设计提供依据。
4) initial water temperature
初始水温
1.
The experimental results show that at a constant initial water temperature, the greater the superheat approac.
实验研究了初始水温、过热度及水位高度对方腔内池水闪蒸瞬态过程的影响,利用可视化方法观察了闪蒸现象变化特点。
2.
Some key parameters such as superheat,initial water temperature and water level have been studied.
实验研究了过热度、初始水温及水位高度对方腔内池水瞬态闪蒸时间的影响。
5) Virgin Static Strength
初始静强度
1.
By using reliability design methods, minimal reliability of virgin static strength of steel thin wall cylinder during pressure test is quantitative analyzed.
应用可靠性设计方法 ,对压力试验时钢制薄壁内压圆筒形容器初始静强度的最小可靠度进行了定量分析。
2.
By using reliability design methods,minimal reliability of virgin static strength of flat ribbon-wound pressure vessels at pressure test is quantitative analyzed.
应用可靠性设计方法,对压力试验时扁平绕带式容器初始静强度的可靠度进行定量分析。
3.
By using reliability design method, the reliability range of virgin static strength of spherical vessel was quantitatively analyzed under the most severe pneumatic and hydraulic test conditions.
应用可靠性设计方法,在最苛刻的气压与液压试验条件下,对球形容器初始静强度的可靠度范围进行了定量分析;结果表明:①初始屈服强度在气压试验时的可靠度为Rs1=94。
6) initial static displacement
初始静位移
1.
Based on the comprehensive numerical analysis of single layer reticulated domes subjected to vertical step load,the effects of initial imperfection and initial static displacement on dynamic stability behavior are presented.
根据大量算例的计算结果 ,分析了在竖向阶跃荷载作用下 ,跨度为 40～ 70m、矢跨比为 1 / 8～ 1 / 5的单层球面网壳的初始缺陷和初始静位移对其动力稳定性的影响。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条