Different ratio of radius to thickness of cold-formed square steel columns are researched by FEM analysis.

bending operation of the foundation was introduces,the plane bending belt conveyor to change the natural mechanics and reasonable method of determining the turning radiuswere described,and explore the impact of the belt conveyor plane bending operation of the relevant factors and the introduction of measures to plane bending belt conveyor design were eplored,the installation and use of provid.

Saturation time headways with different lane widths and turning radiuses were measured on the spot and abnormal data were identified and eliminated.

This article analyses the differences between articulated bus and non-articulated bus when they make turn,and derives the calculation methods of the turning radius and passageway width of articulated bus and the angle between the main bus and the sub-bus.

The design of the Decorative Stainless-Steel Elbow, the calculation of the thinnest thickness of the elbow wall, and the calculation of the smallest relative bending radius of the elbow, the forming die for the elbow and the attention items in the design of the die were introduced.

The strained lattice parameters, misorientation, bending radius and stress of ZnO films were estimated.

Experiments of single mode fiber bend loss with the change of bend radius from 1 to 9 mm are made at 90° and 180°respectively.

Based on field data of the river bend in middle and lower Hanjiang River and in Jingjiang River,the relation between the variation of bend radius of flow dynamic axis and bend bypassing and shoal cutting is expounded.

According to analysis for 03G101-1《Structure of concrete construction drawing plane whole show method drawing rule and construct detail drawing》, to girder and post value of portrait the crooked radius, affect of steel-muscle hoop of the crooked process radius in girder and post argue to the new point of view through main steel-muscle design position.