1.
The Performance of Cold-formed Square Steel Columns Ultimate Axial Compressive Stress under Different Ratio of Radius to Thickness
弯角半径不同对冷弯矩形钢管柱轴心受压极限强度的影响
2.
The formulae for calculating the bend radius of neutral plane and the decrement of bend angle after springback were derived by considering the deformation after unloading.
依据卸载变形的分析计算，推导出回弹后中性层弯曲半径及弯曲角变化量的计算公式。
3.
The bending radius should not less than25 times of cable diameter.
电缆弯曲半径：不小于电缆外径的25倍。
4.
The curve experiment has obtained curve radius of inertia advance curve and static curve;
转弯试验测得了机器鱼惯性前进转弯和静止转弯时的转弯半径;
5.
TUBE DIAMETER SHALL BE WITHIN 10% OF NOMINAL DIAMETER WITHIN BEND RADIUS.
管直径须在直径理论值和折弯半径的10%以内。
6.
This opens up the radius of the turn for you so the turn is less tight.
这会加大你过弯的半径，相对减小弯道的曲度。
7.
Allied M10 Tank Destroyer turn radius increased.
盟军M10坦克歼击车转弯半径增加。
8.
The beam bends to a circular profile of radius R.
梁弯曲成半径为R的园形形状。
9.
HEAVY DUTY AUTOMOTIVE STEERING, with shorter turning radius.
重型自动方向盘：较小的转弯半径。
10.
MANEUVERABILITY. Short turning radius, power steering.
灵活性：较小的转弯半径，动力转向。
11.
Thin-walled Tube with Small Radius and Internal Medium Pressure Forming Technique
薄壁小半径弯管与中压内胀成形工艺
12.
Mathematic calculation approach of minimum bending radius of mandrel based on Matlab
基于Matlab的芯轴最小弯曲半径计算
13.
All sharp corners to have 0.01 Max. Radii.
所有尖角最大半径0.01
14.
ALL INSIDE CORNERS TO BE .38 RADIUS MAX
所有内角最大半径0.38
15.
Enter the ratio of the duct width to the inside radius of the bend. Enter '0' for no inside radius.
输入管道宽度与弯头内半径的比率。如果没有内半径，则输入“0”。
16.
Excellent pliability，flexibility and elasticity and suitable for special occasions requiring small bending radius.
本产品具有极好的弯曲、柔软性和弹性，可用于弯曲半径较小的场合。
17.
Experimental Research on NC Bending with Small Bending Radius of Aluminum Alloy Thin-Walled Tube;
铝合金薄壁管小弯曲半径数控弯曲成形的实验研究
18.
Rounded-entry driveway. Corner radius can be specified.
入口为圆角的车道。可指定拐角的半径。