1) fired pressure
发射压力
1.
This paper establishes a physical model of the collision process and deduces the calculation formula of high-pressure gas fired pressure.
引信双环境力模拟试验系统高冲击加速度是通过高压气体推动冲击块碰撞获得的,本文建立碰撞过程物理模型,推导高压气体发射压力计算式,最后分析了为提高系统的安全性而降低压力的各种影响因素。
2) Acoustic Radiation Pressure
声发射压力
3) field emission pressure sensor
场发射压力传感器
1.
In a new structure of field emission pressure sensor,the cathode emitter array is produced on a sensible film, which makes the alignment and bond between anode and cathode simple.
在一种新的基于真空二极管原理的场发射压力传感器中 ,阴极发射尖锥体和敏感薄膜制备于同一硅片上 ,从而简化了传感器的封装工艺 ,但因此可能导致传感器灵敏度的减小。
4) emission stress
发射应力
1.
The computing data indicates that because cartridge cases are thin walled cylinders,the emission stress and plastic deformation are high under gun pressure.
应用非线性有限元方法计算药筒的发射应力和抽壳力。
2.
This paper mainly analyzed the natural frequency of a gun and the emission stress in the key parts of a gun when it is in lunch process.
本文分别分析了火炮的固有频率和火炮在发射过程中关键零部件的发射应力。
3.
This paper mainly analyzed the emission stress in the key parts of a gun in lunch process.
本文主要分析火炮发射过程关键零部件的发射应力。
6) injection pressure
注射压力
1.
Influence of the injection pressure to plastic mould core offset;
注射压力对塑料模具型芯偏移量的影响
2.
The minimal melt temperature and injection pressure can be predicted very quickly by solving the model using finite difference method when injection time, injection temperature, and mold temperature were assigned.
在给定工艺参数(注射时间、注射温度、模具温度等)的条件下,该模型能快速、有效地预测塑料注射成型过程中的注射压力和最低熔体温度。
3.
This paper researched on the filling flow process of mobile phone housing mould by simulation, and mainly discussed how pressure dependence of melt viscosity and part wall thickness affected injection pressure.
对移动电话外壳模的充填流动过程进行了模拟研究 ,重点讨论了熔体粘度的压力依赖性和制品厚度等对注射压力的影
补充资料：发射
射出（枪弹、炮弹、火箭、电波、人造卫星等）。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条