1) elbow rod fitting model
肘杆合模机构
1.
Discussion of elasticity mechanics properties of elbow rod fitting model for injection molding machine (part one)
注塑机肘杆合模机构弹性力学性能的探讨(一)
2) toggle clamp
肘杆式合模机构
1.
Through analyzing and researching in toggle clamp for manifold models (including back lever model, height of the crosshead, size of middle lever, locking final corner, clamping thrust corner and ratio of the levers' length), the writer is discussing for better model of presented above toggle clamp in the paper.
通过对肘杆式合模机构的多种型式 (包括后杆型式、十字头高度、中间杆尺寸、锁模最终角、合模推力角和杆长比 )的分析和研究 ,探讨了目前该机构中的较佳模式。
3) elbow-bar framework
肘杆机构
1.
In this article, elbow-bar framework of the Die-Cutting system of Blocking Die-Cutter was analyzed with numerical method, and the author also designed an experiment to verify the theoratical analysis.
采用数值分析的方法对肘杆机构进行了分析,并针对分析结果设计实验,通过现场实测取得数据,验证了理论分析的正确性。
4) elbow-bar mechanism
肘杆机构
1.
Optimization design of elbow-bar mechanism in injection molding machine based on genetic algorithm
基于遗传算法的注塑机肘杆机构优化设计
2.
By taking the original errors as stochastic variables,the reliability of the elbow-bar mechanism of automatic die cutting machine was analyzed and calculated in three instances,namely only in the presence of the error of bar length,only in the presence of joint-gaps of hinge or in the presence of the both of them.
将各原始误差视为随机变量,对全自动平压平模切机肘杆机构分别在仅有杆长尺寸误差或铰链间隙误差以及两种误差同时存在的3种情况下,对其输出运动误差进行了分析与综合,建立了机构运动精度可靠性分析模型。
5) Toggle Clamping
肘杆合模
1.
Development and Practice of the New Type Toggle Clamping Mechanismfor Iniection Machine;
注射机的新型肘杆合模机构的开发与实践
补充资料：牵肘
1.谓从旁牵制。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条