1) over-low
超低
1.
Optimize the support of over-low and over-weighted beam formwork by using PDCA theory
运用PDCA理论优化超低及超重梁模板支撑
2) low (ultra-low) carbon steel
低(超低)碳钢
3) low-temperature and-pressure ammonia synthesis
超低温低压
4) ULC steel
超低碳钢
1.
Study on the optimum process of refining ULC steel by RH degasser
RH冶炼超低碳钢的最优工艺研究
2.
Inclusions and total oxygen content in ultra-low carbon(ULC) steel were studied for the control of cluster inclusions in ULC steel.
为控制超低碳钢中的簇状夹杂物,对超低碳钢中的夹杂物和与全氧含量的关系进行了研究。
3.
The polarization curve of the ULC steel with titanium and niobium was measured to determine the suitable electrolytic parameters for preparation of TEM carbon replica samples.
测定了一种复合添加钛、铌超低碳钢的极化曲线,选用合适的电流密度和电解时间以碳复型方法萃取钢中的析出相制备透射电镜观察用样品。
5) cryogenic temperature
超低温
1.
It was found that by adding PPENK and polyether the critical stress-intensity factor(KIC)and impact strength were both highly increased at room temperature and cryogenic temperature.
实验结果表明,加入一定量的PPENK及环氧聚醚后可大幅提高环氧树脂的超低温韧性。
6) ultra-low-carbon steel
超低碳钢
1.
Development on ultra-low-carbon steel mold powder of Baosteel;
宝钢超低碳钢保护渣的开发
2.
Effect of Mould Shielded Fluxes on Concasting Billet Surface Carbonization of Ultra-Low-Carbon Steel;
结晶器保护渣对超低碳钢连铸坯表面渗碳的影响
3.
Composite Treatment of Concasting Mold Flux for Ultra-Low-Carbon Steel;
超低碳钢连铸结晶器用保护渣的超细复合处理
补充资料:超低断面轮胎
分子式:
CAS号:
性质:指断面高宽比低于0.7的轿车轮胎。这种轮胎的断面宽同时以mm和in表示。以165-13/6.5-13规格为例:165表示断面宽,单位为mm,约等于6.5in;13为轮辋直径,单位为in。上述两种标志不是任选一种。而是必须同时标在轮胎上。1in=2.54cm。
CAS号:
性质:指断面高宽比低于0.7的轿车轮胎。这种轮胎的断面宽同时以mm和in表示。以165-13/6.5-13规格为例:165表示断面宽,单位为mm,约等于6.5in;13为轮辋直径,单位为in。上述两种标志不是任选一种。而是必须同时标在轮胎上。1in=2.54cm。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条