1) anti-heating aging
耐热老化
1.
The anti-heating aging property of PP,montmorillonite/polypropylene and ongano-montmorillonite/polypropylene composites(OMMT/PP),in which MMT is modified with 1-octadecyl-3-methylimidazolium chloride was studied.
研究了1-十八烷基-3-甲基氯化咪唑修饰的蒙脱土/聚丙烯复合材料耐热老化性能。
2) thermal-oxydative ageing property
耐热氧老化
1.
In this paper, A new way to improve thermal-oxydative ageing property of damping rubber by preparation of monbnonillonite nanocomposite and modifying technology of carbon black were invesdgated.
实验表明:改性蒙脱土和改性 炭黑能在保持橡胶减震性能的同时,提高橡胶减震制品的耐热氧老化性能。
3) hygrothermal ageing resistance
耐湿热老化
1.
Test methods about hygrothermal ageing resistance of building structural adhesives
建筑结构胶耐湿热老化性能测试方法研究
4) thermal aging property
耐热老化性能
1.
The effect of the sorts and addition level of short fibre on the physical properties and thermal aging property of short fibre/CR composite was investigated.
试验研究短纤维种类和用量对短纤维/CR复合材料物理性能和耐热老化性能的影响。
2.
The results showed that the processibility,scorch time and curing rate changed little as the addition level of EPDM increased up to 30 phr;and when compared to IIR vulcanizate,IIR/EPDM vulcanizate possessed lower cross-link density,higher tensile strength and elongation at break,a little higher tear strength,similar thermal aging property,smaller tanδ at -10~+25 ℃ and greater tanδ at 25~200 ℃.
结果表明,在EPDM用量不超过30份时,随着EPDM用量的增大,IIR/EPDM并用胶的加工性能、焦烧时间和硫化速度变化不大;与IIR硫化胶相比,IIR/EPDM并用胶的交联密度减小,拉伸强度和拉断伸长率增大,撕裂强度略有提高,长期耐热老化性能相当,-10～+25℃时的损耗因子小于IIR硫化胶,25～200℃时的损耗因子大于IIR硫化胶。
3.
The results showed that a NR compound with the highest curing rate was obtained by using 4070/RD,its vulcanizate possessed the excellent flex cracking resistance,thermal aging property,fatigue resistance and hot water extraction resistance,and the comparable light aging property to those by using 4020/RD or 3100/RD.
结果表明,防老剂4070/RD并用胶的硫化速度最快,硫化胶的抗屈挠裂口性能、耐热老化性能、耐疲劳性能和耐热水抽提性能最优,耐日光老化性能相当于防老剂4020/RD和3100/RD硫化胶。
5) heat aging property
耐热老化性能
1.
The influence of the EPDM/NR blending ratio and the multiplex curing system on the curing behavior,physical properties and heat aging property of blends was investigated.
采用硫黄硫化体系和过氧化物(硫化剂DCP)硫化体系对EPDM/NR并用胶实施复合交联,研究并用比和复合交联体系对胶料的硫化特性、物理性能和耐热老化性能的影响。
2.
The effect of TMTD on the curing behaviour,physical properties,heat aging property and permanent set at high temperature of CO/ECO was investigated.
研究促进剂TMTD用量对均聚型氯醚橡胶 (CO) /共聚型氯醚橡胶 (ECO )并用胶硫化特性、物理性能、耐热老化性能和高温压缩永久变形的影响。
6) heat aging properties
耐热老化性能
1.
Influence of curing system on heat aging properties of EPDM;
硫化体系对EPDM耐热老化性能的影响
2.
In this work,the effect of blending ratios of CR/CIIR,curing systems,softening agent,the different kinds and dosages of carbon black on heat aging properties of vulcanized CR/CIIR blends was investigated in detail.
研究了共混比、硫化体系、炭黑品种及用量、软化剂种类等对CR/CIIR硫化胶耐热老化性能的影响。
补充资料：耐热
1.指生物在一定的高温下﹐能维持生命活动。 2.指材料﹑机件等在较高温度下能保持原有的机械﹑物理等性能。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条