3) generation of one dimensional pore pressure
孔隙压力生成
1.
The asymptotic solution for the generation of one dimensional pore pressure is obtained by applying initial layer correcting method.
考虑到弹性多孔介质的渗透系数依赖于孔隙改变的特点 ,给出渗流耦合问题的基本方程 ;用初始层校正法求出了一维孔隙压力生成的摄动解 ;实例计算表明渗流的非线性对孔隙压力分布模式有明显影响。
4) equilibrium hydrate formation conditions
水合物平衡生成压力
5) forming pressure
成型压力
1.
The influence of powder grain size and forming pressure upon the performance of W-Cu composites are discussed in this article.
研究了粉末粒度、成型压力及铜的损耗对钨铜复合材料制备的影响。
2.
The influence of powder grain size and forming pressure are discussed for the performance of W-Cu composites.
着重研究了粉末粒度与成型压力对钨铜材料烧结致密度的影响。
3.
Carbon fiber reinforced sulphoaluminate cement composites(CFSC) was fabricated by press moulding;the influence of forming pressure on smart properties of CFSC was studied.
采用压制成型方法,制备了碳纤维硫铝酸盐水泥基复合材料(carbon fiber rein-forced sulphoaluminate cement composites,简称CFSC),研究了成型压力对CFSC压阻效应和温阻效应的影响。
6) molding pressure
成型压力
1.
Influence of molding pressure and dunking time on the sulfate attack resistant nature of concrete
成型压力和浸泡时间对混凝土抗硫酸盐侵蚀性能的影响
2.
The effect of adding nano α-Al_2O_3 powder and molding pressure on microstructure and properties of micron-sized alumina ceramic was investigated.
为了解决氧化铝陶瓷脆性大、均匀性差等问题,我们在微米氧化铝粉体中添加一定比例的纳米-αAl2O3粉,研究纳米-αAl2O3粉的添加和成型压力对微米氧化铝陶瓷显微结构和性能的影响。
3.
During the process of the consolidation molding consolidation, this paper adopts three schemes to make kinds of samples, while it gives and studies the molding temperature as well as adopts the molding pressure, analyzing the relationship between the molding pressure and the molding thickness.
模塑成型的复合固化中,采用了三个方案复合出几种试样,并对试样的成型温度,成型压力的确定给予了探讨,同时分析了成型压力与成型厚度之间的关系。
补充资料:生成
1.养育。 2.长成。 3.指生物。亦泛指物品。 4.指人民。 5.自然形成;生就。 6.保全性命。 7.必定。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条