1) reverse bending deflection
反弯挠度
1.
The deformation curve of the plate is simulated by means of curve fitting,with the relationship between the intermesh and the reverse bending deflection obtained.
针对某辊式板带矫直机的结构特点,采用大变形法则确定了压下量,并利用曲线拟合方法,模拟矫直时带钢的变形曲线,确定了压下量与反弯挠度的关系。
2) deflection
[英][dɪ'flekʃn] [美][dɪ'flɛkʃən]
挠度;弯度
3) bending deflection
压弯挠度
1.
Design of structural parameters and bending deflection of straightening machine for conducting bar
电铜导电棒矫直机结构参数及矫直压弯挠度设计
2.
It is difficult to get a proper practical answer of bending deflection for H-Beam roller straightening.
H型钢辊式矫直压弯挠度的计算一直难于得出适用工程的解。
3.
In order to avoid flaws in the process of H-beam straightening, an adequate mechanical model was established and the relations between bending moments, forces and bending deflections of the H-beam in nine-roller straightening were deduced.
为了避免矫直过程中出现矫直缺陷,通过建立适当的矫直力学模型,求出了H型钢九辊矫直的压弯挠度与弯矩、矫直力的解析关系,确定了生产中调节矫直辊压弯挠度来保证各辊处的弯矩、矫直力等力能参数的范围。
4) bending deflection
弯曲挠度
1.
On the basis of the mathematical elastic theory, the bending deflection expression of the complex Fourier Series is derived at first for the infinite plate with a unit circle.
应用弹性力学的复变函数理论,首先导出了圆孔无限大板弯曲挠度的复Fourier级数表达式,再把孔的边界条件进行复Fourier级数展开,用待定系数法确定级数的未知系数。
5) flexure
[英]['flekʃə] [美]['flɛkʃɚ]
弯曲，挠曲;弯度;挠度
6) large deflection
大挠度弯曲
1.
In this paper a new analytic solution to large deflection of stiffened plates is presented.
提出了一种加筋板大挠度弯曲的新解法 ,此方法将离散的梁与板结合起来建立一个统一的控制方程。
2.
In this paper, the modified method of multiple scales is applied to study the bending problems for circular thin plate with large deflection under the hinged and simply supported edge conditions.
本文应用修正多重尺度法研究圆板在铰链和简单支承条件下的大挠度弯曲·作出其级数解，分析其边界层效应和证明其渐近性
补充资料：长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条