1) Rolling mill bearing seat
轧机轴承座
2) Roll-chock putting in and out machine
轧辊轴承座拆装机
1.
Roll-chock putting in and out machine was widely used in processing of Roll-chock putting in and out ,for grinding the roll through disassembling the roll chock and guaranting roll quality of surface.
本所研发的轧辊轴承座拆装机采用全液压驱动,造型美观,具有机械性能优良、操作方便、安全可靠、稳定性强、工作效率高等特点。
3) rolling mill bearing
轧机轴承
1.
The deflection angle of tapered roller bearings is one of the most important parameters in design and application of rolling mill bearings.
针对轧机轴承的偏斜角在其设计及应用中的重要性,以单列圆锥滚子轴承在额定动载荷作用下、偏斜角为2′时求得的接触应力和接触变形为已知条件,应用Hertz理论,提出求解轧机用重型四列圆锥滚子轴承偏斜角的方法,为轧机轴承的设计提供了理论依据。
2.
Elastohydrodynamic lubrication(EHL) theory was applied to investigate the effect of inner lubrication behavior on service-life of the rolling mill bearings under heavy load,and the approaches to increase service-life via improving lubrication capacity were analyzed with oil film parameter theory and correction life theory.
采用弹性流体动力润滑理论分析了润滑对重载轧机轴承使用寿命的影响,并用油膜参数理论和修正寿命理论研究了改善润滑、提高使用寿命的途径。
3.
The process and properties of 77752 rolling mill bearing made by 100CrMo7 steel bainite hardening were introduced.
介绍了 1 0 0 Cr Mo7钢制 77752轧机轴承的贝氏体淬火处理工艺及其性能 ;用 1 0 0 Cr Mo7钢制轧机轴承进行贝氏体淬火代替 G2 0 Cr2 Ni4A钢制轧机轴承渗碳淬火 ,具有良好的经济技术效益。
4) bearing mill
轴承轧机
1.
Because of fitting rolling mill before 250mm rolling mill,rolling pass increasing to 17 from 10～12 and taking bearing mill,the highest rolling speed of finished mill increasing to 7 1m/s from 5 5m/s,the process request of once heating into product is meeted.
在２５０ｍｍ轧机前增设轧机，将轧制道次由１０～１２道提高到１７道，并用轴承轧机替代原胶布瓦轧机，成品轧机最高轧制速度由５。
5) roll chock
轧辊的轴承座
6) rolling mill bearing
轧(钢)机轴承
补充资料：邢台机械轧辊(集团)有限公司大型铸铁轧辊的浇注
邢台机械轧辊(集团)有限公司大型铸铁轧辊的浇注
邢台机械轧辊(集团)有限公司大型 铸铁轧辊的浇注
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条