1) rough/middle rolling mills
粗中轧机
1.
This paper is mainly about the design specialties of combined gear reducer in wire and bar rough/middle rolling mills.
本文结合多年来设计线、棒材厂粗中轧机联合减速机的实际情况,阐明了联合减速机设计过程的基本特点,得出了如何选择齿面硬度、齿轮材料及热处理方式,如何确定输出扭矩,如何选择齿轮副的精度、寿命、安全系数,如何进行通用化设计,如何选择箱体结构和轴系结构,如何确定轮齿旋向和齿轮旋转方向,以及如何进行润滑配管设计等主要结论。
2) intermediate rolling train
粗轧机组;中间轧机组
3) four high roughing and intermediate cold rolling mill
四辊冷粗中轧机
4) Roughing and Intermediate Rolling
粗中轧
1.
Numerical Simulation of 4# Angle Steel Roughing and Intermediate Rolling Deformation by FEM;
4#角钢粗中轧过程的有限元模拟
5) cold roughing mill
冷粗轧轧机
6) roughing mill
粗轧机
1.
Breakage mechanism and application of the bottom main drive spindle in a R2 roughing mill during hot rolling by finite element analysis;
热轧带钢R2粗轧机下主传动轴断裂有限元分析与应用
2.
The screwdown system of four-roll reversing roughing mill in Tiangang Group requires high control precision, the speed control of screwdown motor is the key factor.
天钢四辊可逆粗轧机压下系统要求有很高的控制精度,压下电机速度的控制是关键。
3.
In hot rolling process,reheating furnace and roughing mill are controlled separately in general,and as a subsequent equipment of reheating furnace,roughing mill can not feed useful rolling information back to reheating furnace in time,so that reheating furnace can not heat slabs according to the requirement of roughing mill.
在热轧过程中,加热炉和粗轧机基本上是各自独立控制的,粗轧机作为加热炉的后续设备不能及时地把轧制信息反馈给加热炉,因而导致加热炉不能按照粗轧机的生产要求去完成钢坯的加热过程。
补充资料：宝山钢铁(集团)公司热轧带钢厂粗轧机组后的辊道保温
宝山钢铁(集团)公司热轧带钢厂粗轧机组后的辊道保温
宝山钢铁(集团)公司热轧带钢厂粗轧机组后的辊道保温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条