|
|
1) basic triangulation
基本剖分
1.
First, we divide the pointed pseudo-triangulations of pseudo n-gon into two parts, namely, basic triangulations(A(k)) and special triangulations(B) by means of the dual graph isomorphic relation between convex n-gon and pseudo n-gon.
首先,利用凸n边形与伪n边形间存在的对偶图同构关系,将伪n边形的最小伪三角剖分数分为二个组成部分,即基本剖分数(A(k))和特殊剖分数(B)。
2) fundamental profile
基本剖面
1.
A draft of fundamental profile of non-flow gravity dam;
非溢流重力坝基本剖面的拟定
3) atomic data partition unit
基本数据剖分单元
1.
It estimates the amount of computation for each atomic data partition unit by numerical fitting from the computation time of each processor,and calculates the data partition following the principle that the computation time of each processor should be the same.
提出了一种基于计算量拟合的并行数据剖分算法,算法针对并行计算中静态负载不平衡问题,由各处理器实测计算时间,拟合出各基本数据剖分单元的计算量,在此基础上按各处理器计算时间相等的原则确定数据剖分。
4) main soil pit
基本剖面坑
5) basic section modulus
基本剖面模数
6) primary reading profile
基本阅读剖象
补充资料：关于solidworks 中的剖面线中的剖面线
solidworks的剖面线线型定义和autocad相同,它使用了autocad的剖面线定义方法,与autocad通用.因此,可以对剖面线进行定义. 方法:修改\SolidWorks\lang\chinese-simplified\sldwks.prn 用笔记本打开该文件,添加需要的线形.如 ;; Based on AutoCAD Ver.13.0s Hatch Pattern File ;;;; solidworks 区域剖面线定义文件 :: *金属, (Iron BrickStone), ANSI Iron, Brick, Stone masonry 45, 0,0, 0,.125 *塑料, (Lead Zinc Mg), ANSI Lead, Zinc, Magnesium, Sound/Heat/Elec Insulation 45, 0,0, 0,.125 135, 0,0, 0,.125 *玻璃,AR-GLASS@1.0 45,0,0,0,0.5, 0.5,-0.5 45,0,0.1414214, 0,0.5, 0.3,-0.7 45,0.1414214,0, 0,0.5, 0.3,-0.7 *软木, Cork material@1.0 0, 0,0, 0,.125 135, .0625,-.0625, 0,.35355339, .176776696,-.176776696 135, .09375,-.0625, 0,.35355339, .176776696,-.176776696 135, .125,-.0625, 0,.35355339, .176776696,-.176776696 *无, None 删除不需要的定义类型,可以大大提高solidworks 的启动速度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条
|