1) washout experiment
隔离层冲刷性能
3) shock isolation performance
隔冲性能
1.
This paper demonstrated through analysis that selecting proper nonlinear flexible element for a vibration isolation system can greatly improve the system shock isolation performance while keeping its vibration isolation performance nearly unchanged.
隔振系统除了应满足对提出的有关隔振性能的要求外 ,还应满足有关隔冲性能的要求 ,本文分析论证了 :隔振系统采用合适的非线性元件 ,可以在不损害其隔振性能的同时 ,满足其对隔冲性能的要
4) performance isolation
性能隔离
5) scour resistance
抗冲刷性能
1.
The slag α-sialon powder was pressure-less and hot-pressed and the mechanical properties, the scour resistance to YAG, SiC, the erosion resistance to acid of slag a-sialon ceramics were studied.
结果表明,炉渣α-sialon陶瓷有较好的力学性能,优良的抗冲刷性能和抗酸腐蚀性能。
2.
Taking the fly ash from Baqiao Power Plant as example its rationality of compaction test is analyzed from compaction principle, unconfined water-saturated compression strength, scour resistance and other aspects.
以西安灞桥电厂粉煤灰为例 ,分别从击实原理、无侧限饱水抗压强度、抗冲刷性能等角度进行分析 ,指出在工程实际中二灰类材料的实际用水量应较击实试验所得的最佳含水量有所增加。
6) anti-erosion performance
抗冲刷性能
1.
The results indicated that polypropylene fiber can effectively enhance grain s anti-erosion performance,up to more than 40% when appended with a reasonable fiber mixture ratio.
利用MTS材料测试系统,对不同纤维长度和掺量下的聚丙烯纤维水泥稳定粒料的抗冲刷性能进行了试验研究,并与普通水泥稳定粒料进行了对比,分析了纤维的增强机理。
2.
On this basis,the anti-erosion performance of cement stabilized reclyed aggregate base-course mixture material was discussed.
分析了现有的抗冲刷试验装置和道路基层材料产生冲刷的动力源,研发出新的抗冲刷试验装置;采用正交试验设计方法研究了各因素对冲刷量的影响规律,并确定了与装置配套的工作参数;在此基础上,研究了不同再生骨料掺量、不同水泥剂量、不同冲刷次数下水泥稳定再生骨料基层混合料的抗冲刷性能。
3.
Nowadays semi-rigid base material is often applied to base-course in China, but its anti-erosion performance is insufficient so that the cement concrete pavement wreck and the anti-erosion performance of new cement stabilized recycled aggregate semi-rigid base material is rare reported.
现今我国道路的基层主要采用半刚性基层材料,由于其抗冲刷能力不足而导致路面破坏的现象时有发生,关于水泥稳定再生骨料新型半刚性材料抗冲刷性能的研究而又鲜见报道。
补充资料：隔离层
分子式：
CAS号：
性质：为在电学上实现集成电路器件的功能元件的隔离的那一部分。该隔离层特别用于双极型器件，通常由扩散剂制成。隔离层通常为掩模层1或掩模层2，它是遍及整个晶片区域的细线方框。
CAS号：
性质：为在电学上实现集成电路器件的功能元件的隔离的那一部分。该隔离层特别用于双极型器件，通常由扩散剂制成。隔离层通常为掩模层1或掩模层2，它是遍及整个晶片区域的细线方框。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条