1) Exploration and Andlyses about Thin Combustion System
稀薄燃烧系统探析
2) lean-burn
稀薄燃烧
1.
This paper introduces the characteristic of exhausted gas from lean-burn engine and reviews the technique of purifying NO_x under lean-burn condition(especially on HC-SCR).
介绍了稀薄燃烧发动机尾气排放特点 ,并对稀薄燃烧条件下NOx 的净化技术 (尤其是HC SCR技术 )加以综述 ,最后提出建议和设想。
2.
For the LPG engine and the independent cylinder model based on the rotary coordinate system,the lean-burn control strategy using oxygen sensor was introduced.
针对LPG单燃料发动机,基于旋转坐标系的独立气缸模型,提出了一种采用λ型氧传感器的稀薄燃烧控制策略,大大降低了线性氧传感器所带来的高昂成本,并实现了燃气喷射的逐缸控制。
3.
By the experiment,the influences of engine speed,load,compression ratio,spark advance angle and spark-plug gap on lean-burn were analyzed.
通过试验分析了发动机转速、负荷、压缩比、点火提前角以及火花塞间隙对稀薄燃烧的影响,优化了稀薄技术条件下压缩比、点火提前角等参数。
3) lean burn
稀薄燃烧
1.
Study on catalytic conversion for lean burn automobile exhaust gases;
稀薄燃烧型汽车尾气净化的研究
2.
It was found that the Cu/sepiolite catalyst has good anti-water and thermal stable properties under lean burn conditions.
在稀薄燃烧条件下 ,考察了它对汽车尾气中NOx 的还原性能。
3.
A neural network-sliding mode control scheme was presented for accurately control of the air-fuel ratio for lean burn engine in transient condition.
为了对稀薄燃烧汽油机的瞬态空燃比进行精确控制,提出了一个稀燃汽油机空燃比神经网络-滑模控制方案,该方案采用神经网络实现对瞬态过程中实际进入气缸内进气量的精确预测和进气管内油膜动态特性的前馈补偿。
4) lean combustion
稀薄燃烧
1.
Analysis of lean combustion system for vehicular engine;
车用发动机的稀薄燃烧系统分析
2.
This paper introduces lean combustion technology in non-uniform gas inlet and direct injection gasoline engine.
介绍了非均质进气、缸内直喷稀薄燃烧技术,分别介绍了三种统一式和三种分隔式缸内直喷稀燃系统。
3.
The lean combustion skill put a great future in the port fuel injection system.
在车用汽油机普遍采用电控技术,发动机性能普遍得到较大改善的今天,稀薄燃烧技术为汽油机性能的进一步提高提供了广阔的前景。
6) PLBS Partial Lean Burn System
局部稀值燃烧系统
补充资料：稀薄
1.稀少﹐淡薄;密度小﹐不浓厚。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条