说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 缺口平头喷雾器
1)  headed atomizer
缺口平头喷雾器
2)  Throat spray
喉头喷雾器
1.
Objective To investigate bacterial contamination of throat sprays before and after they were used and to search for satisfactory disinfecting method,in an effort to reduce the risk of hospital acquired infections.
目的调查喉头喷雾器在耳鼻咽喉科门诊和胃镜室患者使用后的污染情况,寻求最佳的消毒方法,以降低医院感染率。
2.
Objective To investigate the bacterial contamination of throat spray before and after using,so as to explore satisfactory disinfection methods to decrease the rate of hospital acquired infection.
目的调查喉头喷雾器使用前后的污染状况,探讨有效的消毒方法以降低医院感染发生率。
3)  atmoising device
喷雾器头<火>
4)  duplex atomizer
双喷口式雾化器
5)  spray nozzle
水雾喷头
1.
The selection and the layout of the spray nozzle,which is related to the flow co-efficiency,spray angle and effective range of the spray nozzle,is the primary difficulty in the design of the water spray cooling system.
水喷雾灭火系统常用于液化气球罐的防护冷却,在球罐水喷雾灭火系统的设计中,水雾喷头的选择和布置是主要的设计难点,需要根据喷头的特性如流量系数、雾化角、有效射程的因素进行设计。
2.
According to the collocating trait of sphere's spray nozzle, the effective protective measure of area and the total amount of sphere nozzle can be coculated And this paper introduces a way to calculate the water amount in water spray system for single sphere , then ascertains the total water amount for sphere farm.
根据球罐水雾喷头菱形布置和矩形布置的特点 ,计算出平均每个喷头的有效保护面积和球罐喷头的总数量 ,因此就计算出单罐水喷雾系统的消防水量 ,从而确定整个球罐区的消防冷却系统总用水
6)  water spray nozzle
水雾喷头
1.
Exploitation and experimentation of low pressure intermediate flow rate centrifugal water spray nozzle;
一种低压中速离心式水雾喷头的开发和实验研究
2.
The results of the tests show that: water can be used to extinguish EDA fire;the effect gets better when more water is supplied; under the same water supply condition,sprinkling is better than injection;bigger flow coefficient and spray angle of water spray nozzle will contribute to fire suppression.
灭火效果的好坏取决于供水量,供水越多,灭火效果越好;在供水量相同的情况下,液上喷水比液下注水的灭火效果好;使用较大流量系数和雾化角的水雾喷头有助于提高灭火效能。
补充资料:机械喷雾式干燥器
分子式:
CAS号:

性质: 又称压力喷雾(式)干燥器,喷雾(式)干燥器的一种。液体物料由泵送到装在十字旋转臂上的喷嘴,在一定压力下喷成雾状,与热空气接触而被干燥。空气由送风机送至预热器,热空气从干燥室的上端进入,于底部流经两个袋滤器,从废气排出管排出。已干燥的粉末(包括在袋滤器中回收的)落至卸料螺旋器上而被运走。优点是:(1)适用于逆流操作,同样适用于塔式或箱式干燥器;(2)雾化器价格便宜;(3)可得粗颗粒成品。缺点是:(1)操作弹性小,供液量和液滴直径随操作压力而变化;(2)产品粒度不均匀;(3)喷嘴容易磨损。适用于溶液、乳浊液物料的干燥。不适于含有固体粒子的物料。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条