1) test-tube clamp
试管夹
2) pipe clamp
管夹
1.
The deformation and the stress of the convection superheater are calculated from the structure analysis, and the result indicates that the outlet pipe bend of the convection superheater is the most possible failure and the pipe clamp has great affect on pipe expansion.
对某火电厂#7炉对流过热器进行了结构仿真分析,得到了其热态位移和应力值,结果表明对流过热器出口段外侧管弯头为应力最大区,承重管夹的安装对整个结构膨胀影响较大。
3) Test fixture
测试夹具
1.
The problem of measurements for power microstrip microwave devices is considered, and the LRL(LineReflectLine) method is used to deembed the S parameters from the microwave transistor test fixture.
考虑微带型微波功率器件的测量问题 ,运用 L RL (Line- Reflect- L ine)法对测试夹具去嵌入 ,待测件的散射参量可表为测量值的单值函数 ,消除了嵌入网络参量相位不确定性引入的误差 。
2.
At least three known standards are normally required for the full two-port test fixture calibration in vector network analyzers (VNA).
一般矢量网络分析仪(VNA)的双端口测试夹具校准,至少需要三个已知标准才能实现。
3.
,development of the special test fixtures and software for six kinds of plug-in unit has been accomplished.
雷达领域插件级设计的模块化、软件化、标准化、继承性的推广使得针床测试台的性能价格比得以提高,我们基于美国TERADYNE公司的"Spectrum 8852"自动测试设备,完成了6个品种插件的测试夹具、软件开发。
5) testing fixture
试验夹具
1.
In this paper, a special testing fixture, and testing a specimen as well, are designed for investigating the mixed mode crack fracture and propagation at the tension compression fatigue testing machine.
本文设计了复合型裂纹断裂和扩展试验夹具及试样 ,借助此夹具可以在拉压疲劳试验机上进行多种复合型裂纹断裂及扩展速率试验 ,针对此夹具和试样提出了复合型裂纹长度测量的显微镜直读比拟法 ,并应用设计的夹具和提出的裂纹长度测量方法在 MTS new81 0上进行了多种复合型裂纹扩展速率试验 ,获得了复合型裂纹扩展的 a- N曲线及一些新的结
2.
A special testing fixture of the clips of bar-spring fastening fatigue was designed for the tension-compression fatigue testing machine.
设计了适用于Ⅰ型和Ⅱ型扣件弹条疲劳试验夹具,并应用此夹具在MTS810上进行了扣件弹条疲劳试验,获得了Ⅱ型扣件弹条的载荷随循环次数的衰减曲线及一些新的结果。
补充资料：试管
1.一种圆底柱形或底部为圆锥形的玻璃管﹐亦可用石英或其他材料制成﹐用于化学实验。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条