1) solid contraction
固体收缩
2) solid contraction
固体收缩<冶>
3) solidification shrinkage
凝固收缩
1.
The effect of mechanical vibration on grain refinement and solidification shrinkage of aluminum was investigated in this paper.
研究了振动场对纯Al晶粒细化和凝固收缩的影响,并着重进行理论分析。
2.
The several theory problems that should be paid more attention to,including heat flow rate,solidification shrinkage,mould wall distortion,taper design and corner radius,are put forward and illuminated.
提出并论述了高速方坯连铸结晶器冶金中结晶器热流、钢的凝固收缩、结晶器变形、锥度设计和圆角半径等问题,重点讨论了拉速、碳含量及润滑剂对热流的影响,不同碳含量的钢凝固收缩和相变特征以及结晶器热变形规律,提出了不同钢种的凝固收缩和相变收缩的计算方法和结晶器锥度、圆角半径的设计思路。
4) curing shrinkage
固化收缩
1.
Through the optimization of processing conditions in SMC mold, the optimum pressure release time and the pressure in the second stage are determined , and molding runs are carried out at two-stage pressure, and the mold temperature is reduced as appropriate to reduce curing shrinkage and improve surface-quality in SMC molding.
可显著降低SMC制品的固化收缩率,提高其表观质量。
2.
Based on two kinds of silver powder with different morphology and three matrixes with different curing shrinkage, six electrical conductive adhesives were prepared.
选用三种不同固化收缩率的基体树脂和两种银粉,分别配制了六种导电胶。
3.
Based on two kinds of silver powder with different morphology and three matrixes with different curing shrinkage,six electrical conductive adhesives(ECA) were prepared.
采用2种不同形貌的银粉、3种不同固化收缩率的导电胶基体配制6种导电胶,研究等温固化过程中导电胶基体的固化收缩率以及银粉形貌对导电胶电阻率的影响,探讨导电胶的导电机理。
5) Polymerization shrinkage mass
固化收缩量
6) Volume shrinkage
体积收缩
1.
Influence of volume shrinkage on isothermal crystallization kinetics of polymer;
体积收缩对高聚物等温结晶动力学过程的影响
2.
Effect of CaCO_3 fillers on volume shrinkage of unsaturated polyester and their mechanism;
碳酸钙填料对不饱和聚酯树脂体积收缩的影响及其机制
3.
Volume shrinkage ratio was analyzed from two aspects,the aging-swelling balance and solvent effect.
介绍了三聚氰胺-甲醛凝胶老化过程的溶剂效应及其对体积收缩的影响。
补充资料：收缩中(晚）期喀喇音-收缩晚期杂音综合征
收缩中(晚）期喀喇音-收缩晚期杂音综合征
即"二尖瓣脱垂-喀喇音综合征"。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条