1) vinyl ether
乙烯醚;二乙烯基醚 VE
2) VE acetate
VE乙酸酯
1.
The alcoholysis technique of VE acetatewas investigated in this research.
本实验研究了VE乙酸酯的醇解工艺条件,主要对VE乙酸酯醇解工艺参数,如醇酯质量比、反应温度、反应时间、催化剂用量等做了探讨,用正交法确定了最佳的工艺参数。
3) V_E
VE
1.
Based on single factor experiment including esterifying temperature,esterifying time,and vitriol dosage,the conditions for esterifying free fatty acid were optimized by response surface methodology and by determining acid value and content of V_E as evaluation indexes.
本研究在酯化温度、酯化时间和浓硫酸用量三个单因素试验的基础上,利用响应面分析法,以酯化后脱臭馏出物的酸价和VE含量为评价指标,对游离脂肪酸酯化条件研究。
2.
V_E was purified by hydrogenation and fractionation.
通过氢化、分提工艺对VE 进行提纯 ,氢化工艺条件为 :反应温度 12 0℃ ,反应压力 0 9MPa ,反应时间 2h ,电机转速 70 0r/min ,催化剂用量为原料重 10 % (湿重 ) ,正己烷的加入量为 5mL/g原料 ;分提工艺条件为 :温度 4℃ ,时间 2 4h。
3.
Study on microemulsion of V_E;
以Tween80为表面活性剂,正丁醇为助表面活性剂,通过绘制拟三元相图对食品级VE的O/W型微乳液配方和工艺进行了研究。
4) vitamin E
VE
1.
Optimal Supplementations of Vitamin E,Vitamin C,Choline and Inositol in Feed of Rachycentron canadum;
军曹鱼饲料中VE、VC、胆碱、肌醇适宜添加量的研究
2.
The results show that iodine value of Zanthorylum bungeanum oil no addition vitamin E than addition VE increased 3.
在花椒油中添加VE,考查了紫外光、温度、空气、氧化剂对花椒油碘值的影响。
3.
In this paper,extrusion processing and addition of vitamin E were studied for the stability of rice bran.
采用挤压处理和添加VE对米糠进行保鲜。
5) divinyl ether
二乙烯基醚
1.
The diacid could react with divinyl ether,such as 1,3-divinyloxyethoxybenzene,in solid film when baked above 80 ℃ and the film became insoluble in dilute base aqueous.
丙烯海松酸有大的脂环结构和良好的成膜性,在固体膜层中,它可以和二乙烯基醚,如1,3-二乙烯氧基乙氧基苯,在加热条件下(80℃以上)发生反应,产物在稀碱水中难溶。
2.
A novel family of ester acetal molecular glass materials has been created by the reaction between monocarboxylic acid and divinyl ethers.
通过一元羧酸和二乙烯基醚的反应,我们得到了一种新颖的酯缩醛结构分子玻璃。
6) bisvinyl ether
二乙烯基醚
1.
And these copolymers were used to make a photosensitive imaging system with bisvinyl ether(BPA-DEVE) and photochemical acid generator(PAG).
本研究合成了甲基丙烯酸叔丁酯(TBMA)的均聚物及其与甲基丙烯酸(MAA)、苯乙烯(St)的共聚物,并与二乙烯基醚(BPA-DEVE)和光生酸剂(PAG)构成光敏成像体系。
2.
And systematic investigations about the imaging progress of the "three components" photosensitive affinity switchable system with the copolymers, a bisvinyl ether monomer (BPA-DEVE) and a Photochemical Acid Generator(PAG) were made by using a homemade apparatus for monitoring film thickness change in dissolving, FTS, SEM and so on.
并采用改造后的UV- VIS分光光度计、轮廓仪和SEM等手段对该树脂与二乙烯基醚(BPA-DEVE)和光生酸剂(PAG)相配合组成的“三组分”光敏亲和性变化体系的成像过程和性能进行了较系统考察。
补充资料:乙烯醚
分子式C4H6O,结构简式CH2=CH-O-CH=CH2,分子量70.09,无色液体,易挥发,易燃烧。沸点28.4℃,密度(20/4℃)0.773g/cm3。微溶于水,能与乙醇、乙醚、丙酮、氯仿等有机溶剂混溶。不稳定,应避免日光的照射。主要用作麻醉剂。可由二氯乙醚与苛性钠反应制得。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条