1) suspended water
悬浮水,曝气水
2) air moisture
(空气中)悬浮水分
3) submersion depth
曝气水深
1.
Based upon study of the gas flowrate changes of filler under various filling rates,submersion depth,microporous and single orifice aeration ways,different aeration density and other conditions the hydraulics characteristics of HSL aerobic biological fluidized bed is studied,which provide good references for optimization design of HSL aerobic biological fluidized bed and similar reactors.
通过研究HSL好氧生物流化床在不同填料填装率、不同曝气水深、微孔曝气与单孔曝气两种不同的曝气方式、不同曝气密度等条件下的填料流气量,揭示了其水力学特性,从而为优化HSL好氧流化床及类似的反应器水力学流态提供有益的参考。
4) Drop aeration
跌水曝气
1.
As a result,this paper recommends the integrated constructed terrace wetland because it can make good use of drop aeration,and the wetland covers less land and needs lower cost on running and managing than wastewater plant.
该工艺充分利用山体坡度和水体势能进行跌水曝气,不仅节约了耕地,还极大地节省了运行和管理费用。
6) water-dropping aeration
跌水曝气
1.
The experiments of ultrafiltration of Taihu Lake water with combination of sand filter and water-dropping aeration biological contact oxidation were evaluated.
采用跌水曝气生物接触氧化、砂滤和UF膜分离的联用技术对太湖原水进行试验,结果表明,在冬季平均水温7。
2.
The pre-treatment of micro-polluted source water with three-stage water-dropping aeration biological contact oxidation was studied.
采用三级跌水曝气生物接触氧化预处理微污染水源水,试验结果表明,在水温为8～25℃(平均16。
3.
The experiments of pre-treatment of micro-polluted source water with three water-dropping aeration biological contact oxidation were performed.
采用三阶跌水曝气生物接触氧化预处理微污染水源水,试验结果表明,平均水温19。
补充资料：后曝气
分子式：
CAS号：
性质：指污水处理厂出水中溶解氧达不到一定要求时，需要采取的充氧措施。一般生物处理厂处理后出水中的溶解氧大致为0.5～2.0mg/L，但当受纳水体要求溶解氧最低限度为4～5mg/L时，就有必要设置后曝气，以达到水体对排水中溶解氧的要求。
CAS号：
性质：指污水处理厂出水中溶解氧达不到一定要求时，需要采取的充氧措施。一般生物处理厂处理后出水中的溶解氧大致为0.5～2.0mg/L，但当受纳水体要求溶解氧最低限度为4～5mg/L时，就有必要设置后曝气，以达到水体对排水中溶解氧的要求。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条