1) aqueous suspension
水悬浮
1.
GF/PVC composites was successfully prepared by aqueous suspension, with the application of polymer emulsion adhesion.
采用聚合物乳液作粘结剂 ,利用水悬浮法成功地制备了 GF/ PVC复合材料 ,根据该工艺特点 ,优选了部分聚合物乳液粘结剂 ,并考察了其对成型材料的力学及热学性能的影
2.
The mould powder of ultra-fine A5 booster was acquired by aqueous suspension technology.
采用水悬浮分散包覆工艺制备出超细A5传爆药造型粉。
2) suspension concentrate
水悬浮剂
1.
Development of 10%ZJ0712 Suspension Concentrate;
10%ZJ0712水悬浮剂的研制
2.
The formulation of 10% ZJ0273 suspension concentrate was developed with the method of wetmilling after optimizing the receipt with main adjuvants, such as, wetting-dispersing agents, anti-freeze agents,as well as pH values of the formation.
就10%丙草醚水悬浮剂的配方进行了研究。
3.
Suitable dispersing agents in suspension concentrate of cyanazine and atrazine mixture were screened by flowing point test.
采用流点法初步选定氰·莠 (氰草津·莠去津 )水悬浮剂润湿分散剂组份 ,通过分散剂含量与粘度曲线确定其较佳用量 ,在此基础上利用正交试验设计方法以常温贮存分层率和悬浮率为指标对润湿分散剂、粘度调节剂组份及其配比进行优选 ,确定了较佳配方并进行了贮存稳定性和除草效果验证。
3) aqueous suspension
水悬浮法
1.
In this article, the process of snitched continuous glass fiber mat reinforced PVC composites by aqueous suspension is studied.
介绍了水悬浮法制备连续玻璃纤维针刺毡增强PVC复合材料(PVC/GMT)的成型工艺。
2.
The compatibility of macromolecular binder in suspension solution and PVC resin in glass fiber/PVC composites prepared by aqueous suspension is studied by using DMA,DSC.
采用DMA、DSC、SEM等手段研究了水悬浮法制备的GF (玻璃纤维 ) /PVC (聚氯乙烯树脂 )复合材料中PVC与悬浮液高分子粘结剂的相容性 ,并探讨了其对复合材料性能的影响。
3.
In consideratioin of technical properties of GF/PVC composite materials prepared with aqueous suspension, a model interfacial design is carried out on fiber/matrix interfacial structures, and serial materials are prepared according to the design.
根据水悬浮法制备GF/PVC复合材料工艺的特点 ,对材料中的纤维 /基体的界面结构进行了模型界面设计 ,并根据设计方案制备系列材料 ,考察在材料制备中界面形成的机理及界面层结构与材料性能的关系。
4) aqueous suspension
水悬浮液
1.
Study of Nanometer Powder Aqueous Suspension and Application of it in Exterior Coatings;
纳米粉体水悬浮液的制备及其在外墙涂料中的应用研究
2.
Pre-dispersed nano-sized TiO2 aqueous suspension is requiredduring the preparation of nano-composite latex paints.
纳米TiO2复合乳胶漆的制备一般要求预先分散纳米TiO2并制成水悬浮液。
5) Aqueous suspension
水相悬浮
1.
Production of Chlorinated PVC resins by aqueous suspension method;
水相悬浮法生产氯化聚氯乙烯树脂
2.
The control steps of the thermal chlorination of isotatic polypropylene in aqueous suspension were studied.
研究了等规聚丙烯水相悬浮热氯化过程的控制步骤,认为随着氯化的进行,氯化过程从表面反应控制逐渐转向灰层扩散控制,并且灰层扩散控制对整个过程起主导作用。
3.
This paper was devoted to the chlorination of IPP by aqueous suspension process, which was simple and produced little pollution.
针对聚丙烯(PP)粘合性差、纤维较难染色、低温呈脆性、收缩率大等缺陷，本文采用工艺简单、污染较少的水相悬浮法对等规聚丙烯(IPP)进行氯化改性，探讨氯化机理并建立动力学模型，研究氯化工艺规律，为工业制备氯化等规聚丙烯(CIPP)树脂打下基础。
6) suspended algae
悬浮水藻
1.
Results show that suspended algae has good performance in removing nitrogen and phosphorus from water body.
研究了悬浮水藻在不同温度条件下对营养性污染物氮和磷的吸收去除效果,分析了氨氮和总磷浓度的变化情况和水藻生长情况的相关性。
2.
In order to study the characteristics of suspended algae remove pollutants form slightly polluted water, this experiment researches the low of suspended algae growth and pollutants removing in different pollutant level.
为研究悬浮藻类对微污染水体中污染物的去除特性,本课题试验在不同微污染水质条件下培养悬浮水藻,研究了悬浮水藻细胞密度的增长规律和污染物的去除规律。
补充资料：地下水水资源评价(见水资源评价)
地下水水资源评价(见水资源评价)
d ixiashui shuiziyuan Ping】ia地下水水资源评价见水资源评价。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条