1) side slide block
侧向滑块
2) side slip
侧向侧滑
3) side slide
侧滑块
1.
Introduced the design method of side slide and slanting guide pin demoulding thread mechanism, The practice proved that mold structure was simple and reliable, satisfied the quality requirement.
介绍了侧滑块、斜导柱脱螺纹机构的设计。
2.
By the analysis of the demoulding failure of the side slide of the injection mould andreferring to the principle of ejector pins moving, ejector pins were added in the side slide and thestructure of the ejector pins was improved.
通过对注塑模侧滑块脱模不良的分析,并参考动模顶出杆的顶出原理,在侧滑块上追加顶芯,再进一步改进顶芯的结构,使侧滑块顺利脱模。
4) inside slide block
内侧滑块
1.
Through analyzing on characteristics of the compound material shell, proposed the activity block molding and inside slide block demoulding mechanism, the mold structure was simple and clever, not only reduced the mold cost and the development cycle, more over the mold life was improved.
通过对复合材料电连接器座壳体的工艺分析,提出了活动型块成型、内侧滑块脱模的模具结构,此模具构思巧妙,结构简单,可靠性高,不但降低了模具成本,缩短了研制周期,而且模具寿命得到了大幅度提高。
5) Side slide block
侧滑块
1.
Development of two-step demoulding mechanism at side slide block of injection mould;
注射模侧滑块二级脱模机构设计
2.
Bending Die with Side Slide Block
带侧滑块装置的弯曲成形模
6) lateral chock block
侧向挡块
1.
In light of ballastless track construction practice of Yangcun Extra-large Bridge in Tianjin Intercity Railway Transportation Project,this paper introduces the lateral chock block construction techniques in CRTS II ballastless track bed plate.
结合天津城际轨道交通工程杨村特大桥无砟轨道施工实践,详细介绍了CRTSⅡ型无砟轨道底座板侧向挡块施工技术。
补充资料：侧向挤压
侧向挤压
sideway extrusion
CeXIQng』lyo侧向挤压(sideway extrusion)制品流出方向与挤压杆运动方向成900的挤压方法，也称横向挤压。可分为单向侧向挤压和双向侧向挤压(如图所示)。侧向挤压的特点是:挤压模与锭坯轴线成9扩放置，挤压力与锭坯轴线方向一致，这种金属流动机构使制品遍纂 。b今簿黔 侧向挤压示意图 a、乙单向侧向挤压;‘一双向侧向挤压 1一挤压筒;2一挤压杆;3一模子;4一锭坯;5一挤压制品的纵向力学性能差异最小;变形程度大，挤压比可达100:1，制品强度高;要求模具和工具具有高的强度及刚度。该方法被用来制造高质量的航空用阀的弹簧。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条