1) steering system component
转向系统部件
2) swing system component
转盘系统零部件
4) steering system relief valve group
转向系统安全阀组件
6) turning system
转向系统
1.
The turning system s mathematic model by system identification method was studied.
应用系统辨识方法对轮式移动机器人转向系统的数学模型进行了研究。
2.
However, this technology has not been used widely due to some critical technologies problems such as turning system, hydraulic rock-breaking bit, etc.
利用该技术在早期或老期油气井、压裂效果不好的探井以及近井地带污染/堵塞严重的已开发井中开展试验,取得了较好的增产效果,但由于转向系统、水力破岩钻头等几项关键技术问题,一直没有得到大面积的推广应用。
补充资料:将UG里的一个装配部件输出成单个部件文件
法一:
- 关闭(turn off)FileàOptions->Load Options下"Partial Loading "选项
- 打开装配部件
- 选择File->Export->Part
- 在"Part Specification"下选择"new"
- 选择"Specify Part",指定输出部件文件名称及位置
- 将"Object Selection Scope"设定为"All Objects"
- 选择"Class Selection->Select All"高亮所有对象
- 按"OK"
该种方法特点:每一个部件的特征都会汇集在新部件的MNT里。可以方便编辑。
法二:
- 闭(turn off)File->Options->Load Options下"Partial Loading "选项
- 打开装配部件
- Application->Assembly
- Assemblies->Components->Create New,给出想要输出的部件文件名及路径。
- 如下图1,在ANT上双击新产生的部件文件,使其成为工作部件。
- Assemblies->WAVE Geometry Linker,将设置改为"Body",选择所有组件的体。
- 将"Create Non-associative"开关设为"On",见下图2
- 将产生的部件设成显示部件,仅保存刚产生的新部件,不保存旧的装配部件。
图1 | 图2 |
该种方法特点:每一个部件在新部件的MNT里只会显示一个link的特征。没有相应特征可以编辑。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条