1) compounding extruder
配合挤压剂
2) compounder,compounding extruder
配料挤压机
3) combined extrusion
复合挤压
1.
The physical simulation of combined extrusion about the products with deeper and thinner hole;
深微孔复合挤压成形工艺的物理模拟
2.
The numeric simulation and study of experiments in combined extrusion forming of vehicle hub axles;
汽车轮毂轴管复合挤压成形数值模拟与试验研究
3.
On the basis of analyses of combined extrusion, the upper bound model of continuous velocity fields is defined, the effect of die geometric parameters on neutral point radius is analyzed, and the radius formula is given, the volume distribution of right and opposed outlets is forecasted and verified by experiments.
通过对复合挤压变形特点的分析,建立了连续速度场上限模式,分析了模具几何参数对分流点半径的影响,给出了分流点半径公式,并据此预测了正反出口体积分配比,得到了实验的验证。
4) composite extrusion
复合挤压
1.
Numerical simulation of composite extrusion for internal spline housing;
内花键套复合挤压的数值模拟仿真分析
5) mixing extrusion with corn meal
混合挤压
6) compound extrusion
复合挤压
1.
Through research and manufacture of the cone workpiece, the paper tells a processing that comprises the following methods: compound extrusion , thinned the wall with stretchand processing.
通过对锥形件产品的研制 ,论证了采用复合挤压、变薄拉伸和扩锥挤压相结合的工艺方法是加工深孔薄壁锥形件的可靠工艺方法 ,得出了变薄拉伸加工中加工率不应处于临界加工率状态的结论。
2.
When the shrinkage of the rod fracture surface much more than that of the cup part fracture surface, its formation by compound extrusion is not applicable.
当杆的断面收缩率比杯形部分断面收缩率大得较多时 ,不适合直接用复合挤压成形。
3.
Based on the lance tip of ф245mm,a new forming method was put forward,the compound extrusion simulation model was established,and the hot extrusion process influenced by multi factors was studied by FEM method.
以外径245mm的5孔氧枪喷头上部工件为研究对象,提出了新的成形方案;建立了该产品复合挤压成形的有限元模型,对多因素影响下复合挤压进行了数值模拟研究。
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条