1)  steam isolation valve
蒸汽隔离阀
2)  main steam isolation valve
主蒸汽隔离阀
1.
The structure, system, performance, operation, maintenanciability of two kinds of main steam isolation valve (MSIV) are analyzed and compared, which provides reference for the setat type of MSIV.
对核电站用两种主蒸汽隔离阀的结构、系统、性能、运行和可检修性进行了分析和比较 ,为主蒸汽隔离阀的选型提供了参考。
2.
During the commissioning of the main steam isolation valves it is found that the noise and the vibration are very strong.
秦山核电二期工程主蒸汽隔离阀安装以后,试运行过程中噪音和振动都偏大,设备大修期间发现主蒸汽隔离阀闸板及主蒸汽安全阀阀内件都出现损伤。
3)  MSIV (main steam isolation valve)
主蒸汽隔离阀
4)  primary steam isolation valve
一次蒸汽隔离阀
5)  steam
蒸汽
1.
Foam technology for improving development effect of intermission steam flooding;
泡沫改善间歇蒸汽驱开发效果
2.
Application of rotary steam tube dryer in drying pyrite concentrate;
蒸汽管回转干燥机在硫精砂干燥中的应用
3.
System of Steam Network Collecting Data Online and Simulated and Optimized by Computer;
蒸汽管网实时数据采集与计算机模拟优化系统
6)  Vapor
蒸汽
1.
The process,equipment design and operation of a 120 kt/a sulphuric acid and 150 kt/a saturated vapor sulphur-burning sulphuric acid system in Yancheng Qingsong Sulphuric Acid-Energy Co.
介绍盐城庆松硫能有限公司12万t/a硫酸和15万t/a饱和蒸汽硫磺制酸系统的工艺流程、设备结构及生产运行情况等。
2.
This article introduces the common problem of the structure of vapor pipeline and crude oil pipeline's overhead arm of crude oil pontoon, and the structure's specific demands and the advantages and disadvantages of new and old structure.
20世纪 60年代以来 ,我国沿长江炼油厂原油趸船的蒸汽管线、原油管线跨舱臂结构常出现的问题 ,包括易渗漏、垫片易损坏、补偿性差、内应力大等。
7)  vapour
蒸汽
1.
Through regulating and optimizing condensating and cooling process of coking gas and developing waste heat utilization object of gas the vapour consumption of lithium bromide refrigerator was decreased,the comprehensive utilization of resources and the aim of saving energy resources and decreasing consumption were achieved in the coking plant of Jinan iron and steel group.
济钢焦化厂通过调整优化焦炉煤气冷凝冷却工艺以及开发煤气废热利用项目 ,降低了溴化锂制冷机的蒸汽消耗 ,实现了资源的综合利用 ,达到了节能降耗的目
2.
The weld defects and thermal stress result in failure of vapour wax-removal loop-pipe used in floating roof tank.
浮顶罐蒸汽除蜡装置失效的原因是施工焊接缺陷和热应力破坏。
3.
The transmiting hot oil is substituted for vapour for refining benzene production processing andtransmiting hot oil furnace preressing in the coking plant of Laiwu iron and steel general works.
莱钢焦化厂以导热油代替蒸汽用于精苯生产及导热油炉工艺,经合理设定各项操作参数,提高了精苯加工能力,解决了蒸汽压力不足影响精苯生产的难题。
8)  water vapor
蒸汽
9)  water vapour
蒸汽
10)  aqueous vapour
蒸汽
补充资料:溢流阀、顺序阀、减压阀的比较
溢流阀
减压阀
顺序阀
控制油路的特点
通过调整弹簧的压力控制进油路的压力,保证进口压力恒定,p2=0
通过调整弹簧的压力控制出油口的压力,保证出口压力p2稳定
直控式-通过调定调压弹簧的压力控制进油路压力;夜控式-由单独油路控制压力
出油口情况
出油口与油箱相连
出油口与减压回路相连
出油口与工作回路相连
泄漏形式
内泄式
外泄式
内泄式
进油口状态及压力值
常态
常闭(原始状态)
常开(原始状态)
常闭(原始状态)
工作状态
进出油口相通,进油口压力为调整压力
进油口压力低于出油口压力,出油口压力稳定在调定值上
进出油口相通,进油口压力允许继续升高
联接方式
并联
串联
实现顺序动作式串联作卸荷阀用时并联
功用
定压、溢流或安全作用限压、稳压、保压
减压、稳压
不控制系统的压力,只利用系统的压力变化控制油路的通断
进油腔压力p1控制阀芯移动
出油腔压力p2控制阀芯移动
进油腔压力p1控制阀芯移动
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条