1) PTS (pressurized thermal shock)
加压热冲击
3) shock (-wave) heating
冲击波加热
4) pressurized thermal shock
承压热冲击
1.
Based on the requirements of western codes and rules and the research achievements, the analysis procedures for structure integrity of reactor pressure vessel (RPV) under pressurized thermal shock (PTS) were presented in this paper.
依据法规要求和国外的研究成果 ,对压水堆核电厂反应堆压力容器承压热冲击 (PTS)的研究方法进行阐述。
2.
4, combined with the heat transfer experiments based on the 1 : 10 setup at ambient pressure, numerical simulations were performed to investigate the thermal-hydraulic phenomena of the pressurized thermal shock (PTS), which is caused by the cold safety injection(SI)fluid directly into the reactor pressure vessel (RPV) in the pressurized water reactor (PWR).
为了研究压水堆因“直接安注”冷水注入压力容器下降环腔而导致的承压热冲击(PTS)热工水力问题,基于1:10比例模型,应用计算流体力学软件FLUENT5。
5) PTS
承压热冲击
1.
Numerical Simulation of Heat Transfer Characteristics of RPV Downcomer in PWR under PTS;
承压热冲击下压水堆压力容器壁面换热特性的数值模拟研究
6) impact-compression loading
冲击压缩加载
补充资料:标准操作冲击电压波形(见冲击电压发生器)
标准操作冲击电压波形(见冲击电压发生器)
standard switching impulse voltage waveform
b .oozhun CooZuo ChongJld,onyo boxlng标准操作冲击电压波形(standard switchingimpulse voltage waveform)见冲击电压发生器。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条