说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 感应电势,感应电压
1)  generated voltage
感应电势,感应电压
2)  induced voltage
感应电势
1.
By means of this new method, the nonorthogonally induced voltage risen in the ground resistance measurement can be overcomed practically and the problem of using one circuit overhead line for the ground resistance measurement of large grounding grid is solved.
克服了接地电阻测量中的非正交感应电势的影响,方便、有效地解决了仅用一回架空线路测量大型地网接地电阻的问题。
3)  induced electromotive force
感应电势
1.
Taking parameter variation into account, a new model of the induced electromotive force relation of a permanent magnet synchronous motor (PMSM) was presented.
提出了永磁同步电动机考虑参数变化时精确的感应电势关系式新模型,建立了微分型和非微分型两种高精度感应电势观测器,证明了感应电势观测器的稳定性和收敛性,分析了参数变动对位置估计的影响。
2.
The induced electromotive force at the secondary coil can be got by changing the flux of the primary coil.
采用变磁阻法改变初级线圈的磁通 ,在次级绕组上得到相应的感应电势。
4)  induced potential
感应电势
1.
With the specular-reflection model, the induced potential for a swift diatomic molecular ion moving near a metal surface is investigated.
本文采用“镜反射”模型研究了快速运动的双原子分子离子在金属表面层飞行时产生的感应电势,并借助于一种局域介电函数,分别推导出当离子平行于表面飞行及垂直于表面飞行时感应势的解析形式。
5)  induced voltage
感应电压
1.
Hazard of induced voltage in isolated-neutral power supply system of aluminium smelter and its elimination;
电解铝厂整流系统中性点不接地感应电压的危害及消除
2.
Emulation and study of induced voltage and current for 500 kV double-circuit line on same tower;
500 kV同塔双回线路感应电压和电流的仿真与研究
3.
Problems of induced voltage and current for 500 kV enhanced interconnection systems between Fujian and Zhejiang;
500kV福建与浙江加强联网工程系统感应电压和电流问题研究
6)  inductive voltage
感应电压
1.
To reduce the inductive voltage,shield cable is proposed,or connecting parallel capacitor to power-supply line temporarily.
试验结果表明,开关操作时由于500kV串内连接线和400V电源线间存在电容耦合,在操作电源供电母线上有较高的感应电压存在。
2.
The inductive voltage and inductive current of 500 kV double-circuit transmission lines were calculated and measured on site.
对淄川—益都—潍坊500 kV同塔双回线路的感应电压、感应电流进行计算和实测。
3.
To avoid the influence of the running ways and faults of power system on OPGW and to ensure its regular running, a measure that install composite impedance in OPGW to keep the inductive voltage and current of OPGW within the allowable range is presented in this article.
为了保证OPGW不受系统运行方式和故障的影响而正常运行,文章采取在OPGW上装设复合阻抗的方法,使OPGW中的感应电压和电流在其允许范围之内,保证其能够长期正常工作。
补充资料:标准电极电势
分子式:
CAS号:

性质: 各参与电极反应的物质都处于标准状态(活度为1)时的电极电势。如以下电极反应的标准电极电势为:Fe2++2e→Fe;=-0.45V;C12+2e →2C1-=1.36V。根据标准电极电势可以判定一个氧化还原反应进行的程度。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条