1) burn-out heat flux
烧毁热流密度
2) baking-out
烧毁，过热
3) dry-out margin
烧毁裕度
4) damaged length
烧毁长度
5) heat flux
热流密度
1.
The research of detecting the operatiog states of mechanical. system based on heat flux density;
基于热流密度监测机械系统状况的研究
2.
A numerical method,based on single temperature sensor,constant heat flux assumed and arbitrary number future time steps,was employed to determine the heat flux during rapid cooling on high temperature surface with multiply immersed impinging water jets.
基于单点测温、常热流假设,任意未来时间步长的导热反问题算法求解浸没水射流冷却过程的热流密度;采用有限容积法离散方程,附加源项法处理边界条件。
3.
The meshing requirement of finite element model being considered,the storing technique and the calculating method of heat flux are expatiated.
采用焊接仿真用到的经典高斯热源模型,设计了基于表参数热流密度加载算法。
6) Heat Flux Density
热流密度
1.
But,at the special heat flux density and the special magnetic field strength,the heating rate of oil is higher than the heating rate of water,and with the increasing of the magnetic field strength and the time of magnetization,the heating rate of oil and water is both increase.
结果表明,磁场作用下,油与水的升温速率变化的规律是一致的,但在相同的磁场强度和热流密度的条件下,油的升温速率比水的升温速率要大;随着磁场强度的加大以及磁化时间的延长,其升温速率都明显增加。
2.
When the maximum heat flux density is acquired,the experiment confirms the groove surface size as follows:0.
实验确定了获得最大热流密度时的微槽表面尺寸为槽宽、槽深以及槽间距分别为0。
3.
Secondly,a dimensionless model for finite-element method was established,and 167 706 numerical computations were carried out to study the dimensionless heat flux density on the outer surface of a freezing pipe with constant temperature,and then the relationships between the dimensionless heat flux density and its influe.
应用相似理论将冻结温度场方程和参数无量纲化,然后建立无量纲的数值计算模型,研究了在外表面恒温情况下冻结管壁的无量纲热流密度与各无量纲影响参数间的关系。
补充资料：烧毁
1.焚烧毁灭，焚烧毁坏。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条