1) High heat flux
高热流密度
1.
A series of experiments were done on the heat transfer platform to reveal the heat transferring performance and characteristics of the 316L stainless steel tube with ternary molten salts as transferring fluids under the conditions of high temperature and high heat flux.
以三元熔盐为传热介质,在熔盐吸热传热实验平台上进行高温高热流密度下316L不锈钢熔盐吸热管传热特性试验。
2) high heat flux removal
高热流密度散热
1.
Spray cooling is an efficient method for high heat flux removal.
喷雾冷却是一种高效的高热流密度散热方式。
3) High heat flux component
高热流密度器件
4) heat flux
热流密度
1.
The research of detecting the operatiog states of mechanical. system based on heat flux density;
基于热流密度监测机械系统状况的研究
2.
A numerical method,based on single temperature sensor,constant heat flux assumed and arbitrary number future time steps,was employed to determine the heat flux during rapid cooling on high temperature surface with multiply immersed impinging water jets.
基于单点测温、常热流假设,任意未来时间步长的导热反问题算法求解浸没水射流冷却过程的热流密度;采用有限容积法离散方程,附加源项法处理边界条件。
3.
The meshing requirement of finite element model being considered,the storing technique and the calculating method of heat flux are expatiated.
采用焊接仿真用到的经典高斯热源模型,设计了基于表参数热流密度加载算法。
5) Heat Flux Density
热流密度
1.
But,at the special heat flux density and the special magnetic field strength,the heating rate of oil is higher than the heating rate of water,and with the increasing of the magnetic field strength and the time of magnetization,the heating rate of oil and water is both increase.
结果表明,磁场作用下,油与水的升温速率变化的规律是一致的,但在相同的磁场强度和热流密度的条件下,油的升温速率比水的升温速率要大;随着磁场强度的加大以及磁化时间的延长,其升温速率都明显增加。
2.
When the maximum heat flux density is acquired,the experiment confirms the groove surface size as follows:0.
实验确定了获得最大热流密度时的微槽表面尺寸为槽宽、槽深以及槽间距分别为0。
3.
Secondly,a dimensionless model for finite-element method was established,and 167 706 numerical computations were carried out to study the dimensionless heat flux density on the outer surface of a freezing pipe with constant temperature,and then the relationships between the dimensionless heat flux density and its influe.
应用相似理论将冻结温度场方程和参数无量纲化,然后建立无量纲的数值计算模型,研究了在外表面恒温情况下冻结管壁的无量纲热流密度与各无量纲影响参数间的关系。
6) thermal density
热流密度
1.
The results show that the ignition temperature of Fe-Ti-C system can be decreased greatly under the action of electric fields and great thermal density.
结果表明,在电场和大热流密度作用下,体系的点火温度可以大幅降低,当压力为0～6MPa时,点火温度在310～464℃范围内。
2.
The results show that the ignition temperature of Fe-Ti-C system can be decreased greatly under the action of electric field and great thermal density.
结果表明:在电场和大热流密度作用下,体系的点火温度可以大幅降低;Fe含量越高,其对体系低温燃烧合成过程的影响越大。
3.
The results show that the ignition temperature of Fe-Ti-C system can be decreased greatly under the action of electric field and great thermal density, and the ignition temperature is 390～570 ℃ under different technological conditions.
结果表明:在电场和大热流密度的共同作用下,体系的点火温度得到大幅度降低,且随工艺条件的不同在390～570℃范围内变化;200℃保温2min过程对体系的低温燃烧合成过程有较大的影响,即200℃保温压坯的点火温度和实际所达到的最高温度均高于相应的未保温压坯。
补充资料：高热
高热
〖JP2〗hyperpyrexia
指体温达39～41℃者。小儿年龄越小，体温调节越差，加之小儿的中枢神经系统发育尚不完善，所以发热过高，往往有些小儿会出现惊厥。当小儿出现高热时要积极查明原因，及时治疗。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条