2) post-welding annealing
焊后退火
1.
Studies on the effect of post-welding annealing on the microstructure and properties of Ti-Code 12 alloy showed that the eutectoid decomposition of residual β-phase will take place during post-welding annealing.
８Ｎｉ）焊后退火对组织和性能的影响。
4) primer falling back
底火后退
1.
Fault tree analysis was used to analyze the reasons of the primer falling back and dropping during an interior trajectory test.
运用故障树分析法,分析某产品在内弹道试验过程中出现底火后退和脱落现象的原因,对可能造成此故障的因素进行研究和说明,并对不可排除的三个主要因素进行试验验证。
5) after-annealing
后退火<脱模后退火>
6) post-batch-annealing
后罩式退火
1.
With the aim of producing deep drawing hot dip galvanized sheet of low carbon Al-killed steel on general production line for CQ(commercial drawing) and DQ(deep-drawing) products,the pre-batch-annealing process and post-batch-annealing process were tested on production line.
以在普通热镀锌线生产低碳铝镇静钢深冲热镀锌板为目标,根据CQ、DQ级热镀锌板生产线的工艺特点,设计了以前罩式退火和后罩式退火生产深冲热镀锌板的工艺方案,分别研究了2种工艺对低碳铝镇静钢热镀锌板性能的影响。
补充资料：软化退火(见低温退火)
软化退火(见低温退火)
soft-annealing
rU0nhUO tUihUO软化退火(soft一annealing)见低温退火。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条