1)  water cooled reactor
水冷反应堆
2)  water-cooled reactor
水冷(反应)堆
3)  water-cooled reactor
水冷[反应]堆
4)  light-water cooled graphite moderated reactor (LWGR),gas-cooled graphite-moderated reactor
石墨(慢化)水冷(反应)堆
5)  pressurized water reactor
压力水冷反应堆，压水反应堆，压水堆，加压水冷反应堆，加压水力反应堆
6)  water reactor
水冷反应堆，水慢化反应堆，轻水堆;水[反应]堆
7)  water cooling
水冷
1.
Failure Research for the Water cooling System of ABB High Voltage Inverter;
ABB高压变频器水冷系统特殊故障的研究
2.
The tests included: water cooling manual arc welding cracking test with oblique Y-groove and water cooling submerged arc welding test using welding wire WQ-1 developed by the Technology Center of WISCO and sintered flux CHF101.
根据杭州湾大桥工程的要求 ,对武钢二热轧厂首批生产的 2 0mm厚管桩用钢Q345C -Hq进行了水冷焊接试验研究。
3.
The results showed that the bainite structure can be obtained by water cooling (90℃/s), its properties, special impact value can be remarkably improved.
对这种不含B的微合金钢 ,经水冷( 90℃ /s)可得到贝氏体组织 ,显著提高钢的力学性能 ,特别是冲击性能。
8)  water-cooling
水冷
1.
Discussion on the Special Topics of Water-cooling Hydro-generators and the Selection of Cooling Methods for Three Gorges Hydro-generators;
水冷水轮发电机特殊问题及三峡水轮发电机冷却方式选择
2.
The water-cooling two-stroke gasoline engine oil was developed from base oil made by sour crude,no peculiar smell kerosene,PIB with low molecular weight and some domestic additives including pour point depressant,antirust agent,antioxidant,antiwear agent and ashless dispersant,etc.
以中国石化茂名分公司生产的含硫原油基础油、无异味煤油和PIB为基础油组分,加入国产降凝剂、防锈剂、抗氧剂、抗磨剂和无灰分散剂研制出的水冷二冲程油具有较好的润滑性能和清净性能,达到TC-WⅡ规格要求。
3.
In order to get the different effect on steel ingot inner structure while using ultrasonic vibration under various conditions, the experiments compare with and without ultrasonic vibration on the water-cooling solidified paraffin ingot under different casting temperature and time, and gets a better ingot inner structure under a comparative lower temperature (<62 ℃) while the yield is reduced.
为了探索不同条件下使用超声振动对改善钢坯凝固组织结构的作用,试验对不同浇注温度、时间下有无超声振动的水冷凝固石蜡铸坯进行了对比研究,得到较低温度(62℃以下)时超声冷却对改善铸坯内部结构有很好的效果,但减小了收得率;浇注温度为72℃时,超声作用更多体现在搅拌石蜡液芯上,提高了铸坯的收得率,作用时间长时(20min)可以改善铸坯内部结构。
9)  water-cooled
水冷
1.
The casting process of water-cooled copper metal mould for ductile iron camshaft is presented.
介绍了球铁凸轮轴水冷铜金属型铸造工艺,为了满足球铁凸轮轴的要求(QT700-2,铁素体≤50%),适当加入合金元素Cu、Sn,其中Cu控制在1。
2.
This paper introduced some specialties of shell-tube-styled water-cooled condensers in marine air-conditioners, especially analyzed the differences of this kind of conducer from that on land in such aspects as the material of heat exchange tube, design structure, rot proof technics and the effect of incrustation, etc.
介绍船用空调装置中壳管式水冷冷凝器的特点,着重分析了其冷凝器在换热管材质、设计结构、防腐工艺、水垢的影响等方面与一般陆用空调冷凝器的区别。
3.
Operations and maintenances of water-cooled generators are introduced in this paper.
从设计和运行的角度对大型水轮发电机采用空冷和水冷的方式进行了比较和探讨，并简要介绍了国内几家水内冷机组的运行和维护情况。
10)  water cooled
水冷
1.
It introduce the structure and principle of the mixed air cooled and water cooled door frame applying the cooling door frame can save energy ideally.
介绍了风冷兼水冷混合型冷却门框结构和原理 ,通过实际应用 ,取得了理想节能效果 ,证明了混合型冷却门框的实用
补充资料：反应堆与堆内构件振动监测


反应堆与堆内构件振动监测
reactor and internals vibration monitoring

fony旧gdu一yu du旧e一gouJ一on zhendong Jlonee反应堆与堆内构件振动监测(reactor andinternals vibration monitoring)用以监测反应堆压力容器及堆内构件的振动。 安装在压力容器上的4个加速度仪(l个在容器顶盖的螺栓上，3个在容器的下封头的堆芯中子侧t的贯穿管上)，其信号与容器的加速度振动成正比。 通过采集堆外四个长中子电离室上部第二段和下部第五段的信号，并将其与反应堆功率成正比的平均注量率信号进行标称化处理，送噪声诊断系统，根据每个电离室各段上的差异，以测定堆内构件的振动，并监测异常情况。利用数据库中已有的数据，可以判断引起这种异常的原因。 堆内构件的振型有两种:梁式和壳式。梁式振型用以监侧嫩料组件和吊篮筒体的振动，这种振动改变了堆内构件结构和中子探侧器之间水层的厚度，导致探测器上侧得的中子注量率随上述结构的振动颇率而变化。 壳式振型用以监测堆内构件热屏的振动，这种振动导致堆芯筒体与热屏之间水层厚度的变化，从而影响中子撞击热屏时的能谱。由于热屏对中子的吸收与其能量有关，从而造成中子探侧器上信号的脉动。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条