1) lattice spacing
晶格间距
2) crystal lattice spacing
晶格间距<冶>
3) crystal lattice spacing
晶格间距;晶体点阵间距
4) equispaced magnetic field
等间距磁晶格
1.
The electrocircuit of signal processing and conversion of obtained wave are designed based on equispaced magnetic field of strain detection.
基于等间距磁晶格应变检测的基本原理,设计了信号检测和波形转换电路,将对应变的检测转化成为对时间量的计测,并且推导了时间量与构件应变之间的数学表达式。
5) dendritic distance
枝晶间距
1.
The results show that the variety of segregation parameter is the highest when dendritic distance is 80 μm～120 μm,and the calculated and experimented result of segregation index δ has a .
研究结果认为:偏析指数的变化量Δδ在枝晶间距为80μm～120μm时减小量最大,并且在枝晶间距为120μm的条件下,合金在1160℃退火8h和16h的Nb元素的δ计算值与实验值较符合。
6) dendrite arm spacing
枝晶间距
1.
Quantitative relationship between secondary dendrite arm spacing and solidification cooling rate of AZ31 magnesium alloy;
AZ31镁合金的凝固冷却速率与二次枝晶间距的定量关系
2.
Secondary dendrite arm spacing(DAS) was measured by transvesal method of quantitative metallographic analysis,and the microstructure characters under different solidification cooling rates were analyzed briefly.
用定量金相分析之截线法测定了各个试样的二次枝晶间距,并对不同凝固冷却速度下的组织特征做了简要分析。
3.
The ascast microstructure, chemical composition segregation, dendrite arm spacing, gas content, inclusion and microstructure evolution during CSP rolling process were investigated.
对CSP的铸坯组织、化学成分偏析、枝晶间距、气体含量、夹杂物以及轧制过程中的组织变化进行了研究,结果表明:CSP薄板坯的低倍组织在结构上和传统板坯没有本质区别,但薄板坯组织较为细密,柱状晶比较发达,一次枝晶与二次枝晶间距小,化学成分均匀,铸坯全氧含量为28×10-6,氮含量为47×10-6;第一道次轧制后中心部的疏松和偏析明显减轻,树枝晶沿轧制方向弯曲,但没有被打碎;CSP铸坯中大颗粒夹杂物较少,主要是外来的;内生夹杂物主要以含氧化铝和铝酸盐及氧化钙的为多,尺寸基本都在10μm以内,大部分在2～5μm。
补充资料：融融冶冶
1.美好艳冶。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条