2) laminar eutectic
层片状共晶
3) rod eutectic
棒状共晶
1.
The critical velocity of plane interface growth of MnSb/Sb rod eutectic (fibrous composite) is experimentally obtained by directional solidification technique.
用定向凝固法揭示了MnSb/Sb棒状共晶 (纤维复合材料 )平界面生长条件。
2.
PAN Ye SUN Guoxiong( Department of Mechanical Engineering , Southeast University , Nanjing 210018) A bstract Mn Sb/ Sb rod eutectic co mposites have been produced by Bridgm an technique .
用 Ｂｒｉｄｇｍａｎ 法制备了 Ｍｎ Ｓｂ／ Ｓｂ 棒状共晶复合材料， 得出其组织标度律和平界面生长条件。
3.
Based on correspondence between solidification cell and Saffman-Taylor finger, a solidification model of rod eutectic is proposed and used to indicate that the law of phase spacing selection can be expressed by.
基于定向凝固胞晶与Ｓａｆｆｍａｎ－Ｔａｙｌｏｒ指的相似性，给出了棒状共晶凝固模型，得到表述的相间距选择规律，并用ＭｎＳｂ／Ｓｂ共晶生长实验证实了模型的有效性。
5) eutectic layer
共晶层
1.
The results show that the diffusion dissolution layer in the interface is composed of eutectic layer, transition layer and cellular crystal layer.
研究结果表明,在FADB条件下,AZ31B/Al结合界面处形成的扩散溶解层由均匀共晶层-溶解过渡层和胞晶区构成;外加电场通过降低界面处生成物的激活能,促进了Mg-Al间的扩散反应,所形成的锯齿状结构有利于提高界面连接强度;试样表面的平均硬度及耐腐蚀性能均高于镁合金母材。
6) lamellar liquid crystalline
层状液晶
1.
Rheological properties of lamellar liquid crystalline phase of nonionic surfactant NP-10 in NaNO_3 water solution was investigated.
研究了非离子表面活性剂NP-10在硝酸钠水溶液中形成的层状液晶的流变性。
补充资料：层状共晶体
lamellareutectic：其内至少有一种相是以片层状存在的共晶体。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条